Photos

Pre amp from Gitty. $15.00 US

Posted by Uncle John on February 4, 2011 at 11:05am
My first time to use one of these. I like it! Easy install, sound and volume control and good sound. I may do something w the side sound hole.
Read more…
Previous
Next
Tags: amp, pre
E-mail me when people leave their comments –
Follow

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

Comments

  • keith peterson May 3, 2011 at 12:41pm
    Show us the inside, that is so cool
  • Uncle John February 4, 2011 at 11:59am
    Henry, no instructions, but easy - even for an electronics dunce like me.  No soldering.   1. Cut the hole for the preamp, drill screw holes and mount to box.  2. Drill and install the jack- direct easy wire.  3. Drill a hole small hole where the narrow flat - 3 inch piezo will go through.  4. Run the wire through, glue down the piezo.  5. Groove the saddle to fit over the piezo.  6. Direct wire plug in from piezo wire to pre-amp.  7. Install battery.  8. Cross fingers.  9. Play.
  • Uncle John February 4, 2011 at 11:52am
    Wes, you've seen my photos.  What would I do with a hair dryer?!?!   But that would have been a good idea.  I was able to get it sufficiently (but not totally) flush with the box.
  • Henry Dervaric February 4, 2011 at 11:27am

    Were there perchance wiring instruction as well John?

This reply was deleted.