Posted by Peter Fortier on January 18, 2014 at 4:37pm
The backboard snaps on snugly with rare earth magnets and screw heads countersunk into the perimeter braces. The cone (Old Lowe) is glued on the inside with small wood blocks glued over screw hole locations. The piezo wire is fed thru a slotted aluminum dowel (tent stake) centered in the biscuit. Two small steel angles anchor the neck to the box below the humbucker. Two screws at the other end allow adjustments to the neck angle. Adhesive aluminum duct tape provides shielding.
Read more…
Comments
There's a lot of thought gone into this. Good job.
Nicely done, thanks for sharing!