Posted by Hippy Chip on February 24, 2019 at 4:14pm
Ends beveled, and fretboard edges rolled. I use a larger, thicker cut-off wheel to bevel, and a piece of 50 grit sanding belt stapled to a block of wood to smooth everything out, and roll the fretboard at the same time, then finer grade sanding blocks to shine them up, finishing with 220 grit on a foam block to smooth the sharp corners. Total time was less than 1 hour !!
Read more…
Comments
That is a nice looking precise job.
nice job. cut off wheel on a dremel? are they jumbo frets?