100_0053

To make the table top flush with the side of the blade to prevent the 1/4 strip from going down the hole, I cut a piece of plywood and screwed it to the top of the table, and put a wooden fence 1/4 inch from the side of the blade.
Read more…
E-mail me when people leave their comments –

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

Comments

  • Good solution, Dan.  I have that same tablesaw.  I hate the miter gauge slots and blade insert.  Wish I had my old Craftsman back.

This reply was deleted.