Replies

  • Thanks guys. Re soldered and problem is better.
  • With pieZo it's a bad solder joint....
  • In my experience you shouldnt need to ground a piezo if its wired straight to the jack - Id check ya solder points!
  • Yes, solder a wire between the ground of the pot to the bridge, or any metal part which may have contact with the strings....

    Tim said:
    i dont know much about pizeos but in a typical electic i would say thats a grounding issue.
  • resolder/ cold solder joint
  • i dont know much about pizeos but in a typical electic i would say thats a grounding issue.
  • I haven't had much trouble with 60 cycle hum (or feedback besides) since I started burying my pizeos in a gob of hot glue.
This reply was deleted.