Videos

Comments

• 

  RTZGUITARS November 19, 2015 at 10:27pm

  Thank you so much Nancy, I been feeling good and building the last few months.I have not recorded in over a month but I got this new guitars to play.

   
• 

  Nancy kat November 19, 2015 at 10:07am

  Jeez that is nice Rtzy!!! Not only the guit but the music~ man you are such a wonderful musician! Meeowwwww^..^
• 

  RTZGUITARS November 19, 2015 at 1:15am

  Thanks turtle,  I'm still learnin' 3 string and still looking for tuning and string combo. endless.
• 

  RTZGUITARS November 19, 2015 at 1:07am

  Thanks ,Gary it's just wedged I put it in when I glue the neck in just a little bit of pressure on it when it's dry I screw in the tailpiece.
• 

  Gary W aka Rev. Bluejeans November 18, 2015 at 4:06pm

  RTZ - very nice!  Sweet little build - I like the piezo rod mounted between the thru-neck and the sound board.  Is it just wedged in there, glued...?  Makes a very clean look from the outside!
• 

  RTZGUITARS November 17, 2015 at 10:07pm

  Thanks everyone, the capacitor on the input is a treble bleed of sorts. The high signal is what causes most the feedback on this kind of pickup, works on a disk too but a disk is a disk. With the cap I can turn the volume up all the way on my peavey 15 watt on clean channels without it only a bit passed halfway. High gain amp setting still feedback but I'm getting better usable tone.

  Stewmac sells volume treble bleeds with a resistors on them.

   Fender used caps on the volume pots of old Tele's because single coils sounded harsh but that had something to do with the amp too.

  See what I can do U.J.  
• 

  Uncle John November 17, 2015 at 7:14pm

  Hey, some Merle from you would be good!
• 

  Uncle John November 17, 2015 at 7:14pm

  Well done in every way,. RTZ.  
• 

  Clock The Wolf November 17, 2015 at 7:08pm

  RTZ is da man
• 

  Alex Blackhin November 17, 2015 at 5:03pm

  Great sound. What do you use - is it a resistor at the output ? What is its function -  is it cuts any frequency ?