Photos

Headstock angle cutter jig

Posted by Old Lowe on June 17, 2009 at 1:19pm
The red outline is the neck and piece already cut off my headstock.This cuts it at around 12 degrees and does a very clean cut.Before I was doing this by freehand and it would take a lot of work to clean up the crooked cuts.
Read more…
Previous
Next
E-mail me when people leave their comments –
Follow

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

Comments

  • Old Lowe June 18, 2009 at 12:21pm
    Yeah wade I have used my table saw too but wasn't pleased with the miter saw I can clamp it down tight and goes very slow and make a perfect cut.
  • Wade June 18, 2009 at 11:40am
    I always wondered if this could be done on a cut off saw. Nice job. I used my table saw and then cut the same angle out of scraps and used the pieces on each side to make clamping easier
  • Dan Butler June 17, 2009 at 6:52pm
    Great to see a nice clean work space!!! haha
This reply was deleted.