Dashboard heater amp

I've jammed amps into a few oddball items now, but this one takes the cake. This was an old dashboard heater. 1 watt circuit using a LM386N-4 op amp chip. Volume and gain. Custom lighting. It kind of sounds too bright though as the shell is plastic. Any suggestions on the best material I could use inside it to dampen and take some of the highs out of it?
Read more…
E-mail me when people leave their comments –

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

Comments

  • I'll try that. Thanks Brian
  • Yes, I’m familiar with the lil’ gem, I would definitely try to bump up the input cap. Anywhere from .01- 0.1 ? 

  • It's a 5 component circuit based on the Little Gem. Uses a LM386N-4 chip. The output capacitor is 220uf electrolytic. Input starts at a 0.001 ceramic cap. There is also a 100uf electrolytic in the mix. I can't seem to attach a pic of the circuit here.
  • You could also bump up the input capacitor? Which circuit did you use? The recessed speaker is acting like a megaphone & projecting the highs? Good luck 

  • The speaker is in the only place it could go. I can try a different capacitor, or thinking of placing some foam sheets inside it
  • Bump up the output capacitor or move the speaker closer to the opening?

This reply was deleted.