Miller Custom Cigar Box Guitar Tips, Tricks, Tools and Techniques Video Series In this episode Bryan Miller shows you how to make a pair of fret cutters from...
You need to be a member of Cigar Box Nation to add comments!
Randy, a Dremel that close to my birdseye maple or old growth walnut scares the shit out of me. I have screwed up more than one fretboard with power tools :)
That same idea with the nippers was done by jim frets years ago...he might still have some vid`s on youtube. You should check him out....he was building bad ass homemade guits when we were all youngins.
Comments
Tank you very much for sharin...°<[:-) [---]==={...
Thanks for the feedback everyone!
Randy, a Dremel that close to my birdseye maple or old growth walnut scares the shit out of me. I have screwed up more than one fretboard with power tools :)
Thanks for posting this. Nicely produced.
That same idea with the nippers was done by jim frets years ago...he might still have some vid`s on youtube. You should check him out....he was building bad ass homemade guits when we were all youngins.
well since i do 95% of my custom work with a dremel it`s a no brainer to use it for dressing frets.
I use a diamond disc on my dremel , cuts the fretwire at an angle plus i can use the surface of the disc to fine sand the end of the fret.
harbor freight has knippers for $7. 20% coupon gets them for under $6
cool. Now how do I make a grinder? just kidding. Great tip!