I'm sorry I don't have a schematic that I can send, but the book I mentioned earlier has everything you need, and will be worth the investment to help you troubleshoot your build.
Be patient, it took a lot of tries to get it to work for me, but then again, I was new to all this. One thing I did find out, you gotta get the fuse right!
Hi Tim
Can u send me the parts list for this build? And is that a stereo or mono input 1/4" jack?
I have both, plus all variety of caps, resistors , LED's and pots
Looking at your breadboard can you send a drawing schematic along too?
This is cool stuff. I have everything I need including the breadboard
Thanks
Roy
Comments
Hello Tim
I receive my book today. Just what I needed! thanks for the recommendation
Take care
Decision you won't regret, believe me!
Since i have jumped into this with both feer forward
Hi, Roy, here's the parts list for what I build:
- box
-knob
-grill cover
-22 awg wire
-0ne 220uF 35v electrolytic capacitor
- one 8 ohms 3" 0.7w or higher speaker
- one LM386N-3 amp chip
-9v battery
- 9v battery connector terminal
- one 2.2K resistor
-one LED lamp 3mm-5mm
- two DPDT toggle switches (on/off 6 lugs)
- one 2K ohms volume pot
- one 1k ohms tone pot
- one 1/4" mono jack
- one mini auto fuse holder (1/4" x 1 & 1/4")
- one 1/2Amp 1/4" x 1 & 1/4" glass in-line fuse
I'm sorry I don't have a schematic that I can send, but the book I mentioned earlier has everything you need, and will be worth the investment to help you troubleshoot your build.
Be patient, it took a lot of tries to get it to work for me, but then again, I was new to all this. One thing I did find out, you gotta get the fuse right!
Can u send me the parts list for this build? And is that a stereo or mono input 1/4" jack?
I have both, plus all variety of caps, resistors , LED's and pots
Looking at your breadboard can you send a drawing schematic along too?
This is cool stuff. I have everything I need including the breadboard
Thanks
Roy