just make sure the board where you clamp the neck to is square to the blade and table , it could be made for adjustable angles by using a screw at the front on the tracking slot underneath and having a removable screw holding the track guide at the rear from the top, just a thought,,i havnt got around to refining the jig yet,it was just an experiment caused by frustration but it worked fine,im also altering my tablesaw to accept 12 " blades so I can cut wider stock,,have fun
Comments
Perfect.
just make sure the board where you clamp the neck to is square to the blade and table , it could be made for adjustable angles by using a screw at the front on the tracking slot underneath and having a removable screw holding the track guide at the rear from the top, just a thought,,i havnt got around to refining the jig yet,it was just an experiment caused by frustration but it worked fine,im also altering my tablesaw to accept 12 " blades so I can cut wider stock,,have fun
Great jig! you can use the full height of your saw blade. I may have to make a new scarf joint jig for my table saw. Thank you!
Cheers Dan that looks easy enough to make.