What do you use to cut slots for the neck? I use a little pull saw buy have to use a small rasp and sand paper to clean it up. Was wondering if there was a better way. Only have built a few cbg's.
You need to be a member of Cigar Box Nation to add comments!
Replies
Roger,I use my table saw.I just set the depth i need on the blade,mark the box then put masking tape on the inside of the cut so it will not splinter out.I also put making tape on the line to be cut so it i easy to see.The only draw back is that on some boxes i have to remove the lid. You have to make a few passes to get the size,but works for me.Happy building! Moon
OK my mistake sorry. I was talking about the slot in the box not in the neck.