If you aren't installing a truss rod, is there any reason to glue a fretboard onto the neck? I've seen quite a few people doing this and it surprised me.  Just for aesthetic reasons?

I was planning on simply installing frets directly onto the main body of the neck. Any reason not to?

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

Email me when people reply –

Replies

  • Assuming you are building a through-neck design, a 1x2 (probably even an oak 1x2) will bow unless you build it up with a 1/4" fretboard on top.  I also add material to the bottom of the through neck inside the box, as well as a heel where the neck meets the outside of the box just to make sure.

    Additionally, if you don't build up the fretboard, your nut and bridge will be too short--strings will be too close to the box for picking and won't deliver any volume.

  • A separate fret board is not a must. Just look at some Fender guitars and you'll see many have a hard maple neck with frets inserted directly into the maple.

    I've built guitars with and without fret boards. Personally, I like adding a fret board in a contrasting wood color. It does add some strength to the neck, but with a good hardwood neck, not essential. It gets the string height up off the cigar box top, but if you cut a deeper step in the neck (where it intersects the box) you can accomplish pretty much the same thing.

    In the end, I think it just a builder's choice. I like fret boards, but a lot of high end Fenders managed without them. Again an example of "No Rules".

  • Hi, I use a fingerboard for a number of reasons. 

    It adds strength or stability to the neck.

    depending on what a neck is made of, a hardwood f/b will hold frets better

    it allows for better nut fitting and break angle of strings to tuner posts

    it easier to get the bridge height correct with the way I fit my necks to the box

    it seperates a cheep looking instrument from a more quality instrument 

    it does cover the truss rod channel, but you can have a rod in a neck without a f/b.

    Bottom line....No you don't have to have a fingerboard.......if you got suitable neck timber.

    Taff

This reply was deleted.