I read the discussion on the board where Matteo asked pretty much the same question and David L. gave an answer and there was a link to a wiring diagram. I have also looked on Seymour Duncan for wiring diagrams they have something that is close but not like my preamp.I was thinking this post is right on time. Matteo must have got his figured. I am not that lucky. I have got 3 of these things going at one time and the mounting holes are cut so there is no backing out. I have a prewired volume tone and 3 way switch from CB Gitty and a preamp.I have a rod piezo under the bridge and 2 each 27mm piezo disc wired parallel in a plywood sandwich under the lid at the base of a bolt on neck.. The jack on the preamp plug acts as an on/off switch. My vision is to be able to route all signals through the preamp. Be able to have disc and rod either separate or together. I have taken the rod piezo that has the 1/8 mini plug and cut it in half soldered black wire to the outer braided shield.and red to the inner conductor. I soldered the disc + to one outside leg of the 3 way and the rod + to the other. Question Is: What next? Or can somebody put me on a link using the components I have. I have taken pix and would really appreciate some help on this. I am sure somebody has made this setup using these components.
You need to be a member of Cigar Box Nation to add comments!
Replies
Next step is to get the signal from the piezos (rod and disks) to the preamp from the 3 way toggle switch. Then from preamp to the volume/tone controls and last, the jack.