Forums

Replies

  • Hip Bone Bellaire April 25, 2014 at 7:48am

    WOW great ideas.. thanks this gives me a starting point...

  • robert jones April 25, 2014 at 7:35am

    A coping saw with a fine tooth metal cutting blade works well since the speed of cutting is slower than a scroll saw..

    The blades cut better if you rub beeswax or Ivory bar soap on the teeth to act as a lubricant.

    If your lid is aluminum you'll want to have a good stiff wire brush on hand to clean out the teeth periodically.

  • Ron "Oily" Sprague April 25, 2014 at 5:54am
    Drill punch a pattern in it.
  • gary herget April 24, 2014 at 8:00pm

    If you have a Dremel you can attach a cut off wheel to make your cut.

  • The Phrygian Kid April 24, 2014 at 7:49pm
    Sounds more like a job fr a bandsaw/grinder to me, but what do you have to lose? Surely the scroll saw blade will break before the motor is damaged. Nasty edges is what the good lord gave us sandpaper for :)
This reply was deleted.