Tim Mac
  • Male
  • Greensboro, NC
  • United States

Tim Mac's Friends

  • Jay Caughron
  • Randy S. Bretz
  • Old Lowe
  • bairfoot cajun

Tim Mac's Page

Profile Information

How did you learn about Cigar Box Nation?

Comment Wall (5 comments)

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

At 2:28am on January 10, 2014, Randy S. Bretz said…

Your Thumb Slide with Rosewood top

At 6:49am on December 28, 2013, Michael Fred Johnson said…

Hi Tim,

The ply is 3.6mm thick as sold by B&Q a U.K d.i.y. store. It really is cheap nasty stuff with faults in the veneer facing and even occasional voids within the ply.Guess where it comes from ? - not Scandanavia. You have to be very selective when buying a sheet. I had always intended to paint this one anyway.

At 8:55pm on December 25, 2013, bairfoot cajun said…

howdy tim,i stopped by to answer your questions about the resonator coverplate.i leave it flat after cutting it but i use hole punches to make the inner holes around the center hole and when i punch them it leaves an uneven surface so to make it all smooth again i use a brass hammer to hammer it out from the underside( cause i punch the holes from the top side)when i hammer it out smooth it makes a slight arch to the coverplate any uneven ridges there may be in inner surface areas of the holes i usually use a fine line half round file to remove then sand edge with average grit sandpaper.oh also when i am hammering the coverplate from the underside i set it on wood surface instead of metal and that helps to preserve the patina of the surface of the coverplate.also you asked about regular baking pan---the ones i look for are well used and have the patina prebaked on the surface from many cakes being baked in them.sometimes i like the look of the outside of the pan better when its patina looks nicer and more evenly distributed.thanks for your interest and your questions.have fun and hoped what i had to say helps you out.

At 4:05pm on December 23, 2013, Jay Caughron said…

Hey Tim I haven't had a chance to look through the pile yet for a good wide board but will try to by tomorrow. My phone # is 417- 744-4211 and my email can be found on my http://frogpondguitars.com  site


At 12:28pm on December 22, 2013, Jay Caughron said…

Tim I have about 2000 bf of it mostly Full 2 by stuff. I was told it was milled around 1850 and came out of a old Grits mill in Alabama. 


The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building BasicsCigar Box Guitar Parts Store

Site Sponsor

Recommended Links & Resources


LM386 Amps, AliExpress

Started by Patrick Allison in Performances, How to Play, Lessons, Concerts. Last reply by Patrick Allison 3 hours ago. 2 Replies


Started by Lennox Gavin in Performances, How to Play, Lessons, Concerts. Last reply by Tim Pannabecker on Sunday. 3 Replies

Problem CGB

Started by Thomas Rasmussen in Performances, How to Play, Lessons, Concerts. Last reply by Thomas Rasmussen Mar 14. 18 Replies

Nylon Strings

Started by Mark Rinehart in Building Secrets, Tips, Advice, Discussion. Last reply by the anonymous pick Mar 13. 1 Reply

South Africa

Started by Marius in Performances, How to Play, Lessons, Concerts. Last reply by the anonymous pick Mar 12. 1 Reply

Latest Activity

Joe Caruso commented on BeetleJuice!'s video
15 minutes ago
Derek Rose commented on Derek Rose's video

Into the Mystic - on a 3 string

"Thank you for your kind comments Joe!"
38 minutes ago
Poorness Studios posted a photo

Found a speaker grille for the CBA

Now I won't accidentally stab a screwdriver thru the speaker on the bench. I'll do a video this…
1 hour ago
Dave Lynas commented on Matthew Borczon's video

go tell aunt rhody

"I listened again Matthew. It’s plane Wonderful. Thanks for fiddlin."
1 hour ago
Dave Lynas commented on Dave Lynas's photo

Old 97

"Thanks Thorsten. Been a whirlwind in the thorn trees. Two builds born the same day. Equinox gifts…"
1 hour ago
Dave Lynas commented on Dave Lynas's photo

Old 97

"Thanks Thorsten. You just posted a fury guit right? Pretty far out!"
1 hour ago
Dave Lynas commented on Dave Lynas's photo

Added some style

"Thanks for the like AGP. I’ve been playing her tonight. She can be very sweet. And pure…"
1 hour ago
AGP # commented on Uncle John's photo
1 hour ago
AGP # liked Uncle John's photo
1 hour ago
Denny shared micky rooney's video on Facebook
1 hour ago
Denny liked micky rooney's video
1 hour ago
the anonymous pick commented on Dave Lynas's photo

Finished Lap with Supro pickup

"hella sharp . !!! she's a beauty !!"
1 hour ago



© 2019   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->