Replies to This Discussion

Permalink Reply by Tex Pierce on September 7, 2016 at 1:47am

Please, any help at all, trying to figure out if I can run stomp box and guitar through the same amp without a lot of trouble. Thanks for your help!

• ▶ Reply

Permalink Reply by Timothy Hunter on September 7, 2016 at 2:09am

whats the stomp box pickup? the CD/AUX/MP3 input is probably what they call line level. plugging in the stomp box wont hurt it but it might not have much volume . you might need a preamp or booster between the stomp box and the input.

• ▶ Reply

Permalink Reply by Tex Pierce on September 7, 2016 at 2:50am

It's a  standard humbucker  with 9 volt power. The amp is a roland GX10. Thanks for your help!

• ▶ Reply

Permalink Reply by Timothy Hunter on September 7, 2016 at 11:33pm

just downloaded the manual for the amp. nice little amp those cubes...

Aux in is mixed with the guitar signal just before the power amp section of the circuit. so it does have to be line level . the manual also warns about resistance in the cable which i assume means a volume pot in the output? it does mention to adjust the volume from the device being plugged in.a simple preamp to boost to line level would work fine adjust output volume of the preamp by adjusting the gain of the preamp. just make sure that the max gain doesnt push past line level voltages... 1V peak to peak

• ▶ Reply

Permalink Reply by Tex Pierce on September 7, 2016 at 10:53am

What about through a mike input?

• ▶ Reply