Hi Everyone, i would like to wire a single 20mm piezo to a A500k volume and a B500K tone control without a 3 way switch but cant seem to find any diagrams for one. Is it possible to do this and if so what options do i have for fitting a capacitor to them?
Many thanks in advance Paul.
You need to be a member of Cigar Box Nation to add comments!
Replies
Hi The Phryrgian Kid, thanks for your quick reply.
Have you any suggestions on what type of preamp i could use and if its possible to make my own
and how it should be wired up?
Did alot of electronics when i was younger but now in my 50's and the old grey matter aint what it used to be lol !
Thanks Paul.
You can use the Tillman preamp circuit. It's good and simple enough to solder up on perfboard. I put it in nearly all my gats. Runs 1000+ hours on a 9v.
For a passive tone control - yes it IS possible! - go to my discussion here.
http://www.cigarboxnation.com/forum/topics/passive-tone-control-for...