Forums

miter (2)

Fretting about Frets, are they square?

I see most of the CBGs have straight necks, so squaring up the frets shouldnt be a big deal. What about if you are making more of a Uke-type neck where one end is wider than the other? How do you get those squared up? Do you mark the frets before cut

Compound miter saw jig

Excuse me if this has been dealt with already. I searched for it, but all I found were table saw jigs. I just bought a sliding compound miter saw. I want to make 15 degree necks. Can anyone point me in the right direction for how to proceed? Do I nee

Hello, you need to enable JavaScript to use Cigar Box Nation.

Please check your browser settings or contact your system administrator.

Fretting about Frets, are they square?

Compound miter saw jig

Note: this page contains paid content.