I want to use Gitty's Bridge with Embedded Rod Piezo with a male 2.5 plug that would go into an end pin strap button jack.
How do I add a volume pot to this ?
You need to be a member of Cigar Box Nation to add comments!
This reply was deleted.
I want to use Gitty's Bridge with Embedded Rod Piezo with a male 2.5 plug that would go into an end pin strap button jack.
How do I add a volume pot to this ?
You need to be a member of Cigar Box Nation to add comments!
Replies
WOW ! Many, many thanks...the graphic is just what I needed.
(I am a visual learner at heart !)
The wire from the rod to the 2.5mm jack plug can be cut to allow you to add a volume pot (I use 250K others use higher or lower)
The wire consists of an outer braided silver carrying the ground part of the circuit (and acting as a shield for the live wire) and a plastic coated live wire inside. Once cut you can tease the braid to one side and twist to give a negative and carefully strip a little off the inner plastic sleeve to find the live wire. as below
To incorporate a volume pot wire as below
Hope this makes sense if not please ask.
Regards,
David