Will T's Friends

View All

Will T's Groups

6 string CBG's

241 members
197 Comments 16 Likes
CBG Tabs

603 members
241 Comments 47 Likes

Piezo pickups

202 members
101 Comments 11 Likes
Banjo Players Unite!

100 members
88 Comments 8 Likes

Home Made Resonator Boxe…

232 members
177 Comments 24 Likes

View All

Will T's Discussions

Nut string spacing - 8 string CBUkulele

Started this discussion. Last reply by Will T Aug 22, 2016. 6 Replies 0 Likes

I am going to build my first 8 string CBUke - (4 pairs of strings). The G & C will be tuned an octave apart / the E & A in unison. I would welcome advice on string spacing. I am planning to…Continue

Working With Lacquered Boxes

Started this discussion. Last reply by Will T Feb 10, 2015. 6 Replies 0 Likes

Fellow CBG Builders -There's a nice high end "cigar bar" near me that always has a good selection of high quality cigar boxes for sale. I recently picked up two beautiful lacquered boxes from them.…Continue

CBG Top Woods - Leave As Is?

Started this discussion. Last reply by Ron "Oily" Sprague Aug 25, 2014. 10 Replies 0 Likes

Hi Folks:So far I've built a variety of CBG instruments: 3 & 4 string guitars; bass guitars; and various ukes. Most have turned out pretty decent. I would really appreciate hearing opinions,…Continue

Tags: spruce, woods, top

Dimensions For 5 String Banjo Neck

Started this discussion. Last reply by ChickenboneJohn May 5, 2014. 6 Replies 0 Likes

Hello all -So far I've built a number of different "Cigar Box" instruments. 3 & 4 string guitars, ukes, a 4 string bass, and most recently a "cookie tin" guitar (see pic). I'd like to try…Continue

Tags: build, tin, cookie, neck, Banjo

View All

Will T's Page

Profile Information

How did you learn about Cigar Box Nation?: On-line

Comment Wall (1 comment)

You need to be a member of Cigar Box Nation to add comments!

Join Cigar Box Nation

At 6:18am on September 11, 2013, Battmann said…: thanks, will

if you can build the cbg then a ukelele is no problem. i just use the same system.this was my 2nd ukelele.but this time i decided the taper the neck,more room for your fingers. so t took way long than usually because i wasnt sure what i wanted to do. it went with a the tenor scale of 18 inches/ 18 frets. i marked and cut the nut slot and fret slots before i tapered the neck. i knew i wouldnt have a 90 degreee to hold a square to after tapering. i went with 1 .5 at the nut and 2 inched at the last fret. my may go 1/8 thinner on the next one. the nylon strings take quite a while to stretch out and sound good. for about 3 days i was disapointed with its sound, seemd out of wack. but then it all came together. i have a simple sled withholds for tapering. nothing fancy or scientific about it. after rounting the nut slot and cutting fret positions i take a 1x3 and trim it done to 1.5 starting at least 5 inches above nut slot. . cutting same amount off both sides. then i measure about 1/2 past 18th fret. , mark board so the end will be 2inches wide , clamp the board to the sled.,align board to pencil mark atwide end. ,align board at 1.5 ( nut end ), clamp and cut..flip it over and cut other side. hope sthis helps,Bruce