I just bought my first real practice amp -- a 25 watt Washburn. I plugged in my latest build (which has 2 humbuckers and a Tele control plate) and it sounds great, but when I flick the amp's overdrive switch, it gets noisy (ha ha) with the usual grounding-problem hum. When I touch a finger to the metal jack plate, the hum drops off.
Am I supposed to run another ground wire to the jack plate, or is there something wrong with my Washburn amp?
Tags:
Hiya, You will need a wire from any part of the ground circuit, usually one is run from the back of the volume pot, up to under the bridge, it only has to be touching the bridge, no soldering is required on this end. This will ground your strings and will have the same effect as touching the jack plate.
Hi Jeremy:
I have already grounded the bridge, which grounded the strings and the trapeze tailpiece I used. The only things making noise are the jack plate and, to a lesser extent, the adjustable screws on the pickups.
Mister Scott (the Nacho Libre face wrestling mask on your profile pic still cracks me up, because I imagine James Doohan saying, "Captain, I canna hold 'err enny longurrrr!"),
Anyhoo, if you've wired your ground from the pot to the proper lug on the jack itself (which should be the one that connects to the inside ring of the jack, not the lug that is part of the outside ring that has the long tip), then the jack plate should also be grounded, since it holds the jack itself in place. All of your grounds from bridge, pickups, etc. should terminate on the back of the pot, according to most of the wiring diagrams I've seen, and then a single ground wire runs to the ground lug on the jack. Can you post a photo, sketch or diagram of your wiring set-up?
Also, it could be that the ground on the back of your pot may just be loose, or improperly soldered. Many people seem to be having trouble lately with proper soldering of the ground to the back of the pot (me included), usually not scraping enough down to bare metal on the back of the pot. I'm seeing lots of posts here lately about having to resolder ground wires. Another issue could be a loose connection in your guitar cable; some of mine go wonky when I least expect it, because they get pulled on so much. Then, see if your amp has a 3-pin plug (it probably does, but it never hurts to ask) as opposed to a two-pin; that third pin is your ground into the wall socket. Sometimes, the smaller practice amps are incorrectly grounded and or shielded internally, as well, even when they bear the UL listing seal of approval.
Electricity is a beeyotch, ain't it? Trying to give advice without seeing the setup, much less being able to trace the current with a multimeter, puts one in the same position as the tech support guy with the script on the computer help desk phone bank: "Is your machine plugged in? Have your turned on the power switch? Have you..."
S-O-N-T,
Thanks for your message. THere's a lot of helpful info there. Here is an update of this situation:
Before you sent your message, I resoldered a number of the lugs and grounds in the build. i replugged it in to the practice amp, and the problems were still there.
I tried out 2 other CBG builds of mine that were sitting near, and both of them had the same issues as that latest build: ground hum when I touch the pickup screws or jackplate while plugged into he practice amp.
Now here's the kicker: I dug out my 2-watt, battery powered Danelectro mini-amp. NONE of the grounding issues were there. This leads me to believe I bought a faulty used amp, and I'm not sure how to fix it.
S-O-N-T,
It was an amp i purchased at a Pawnshop. It's a Washburn Bad Dog BD25R. It has 2 channels, and on the first channel, the hum isn't so bad. It's when I select channel 2, which has the Overdrive feature, that hum becomes really noticeable.
Scotty,
Here's what I got so far: one reviewer at FixYa.com, in a post on a related Washburn amp, say the capacitors on the power block are used to cancel the 60-Hz hum that comes from your house current. It is possible that one of these is bad, or maybe one in the Overdrive channel on your amp. Another reviewer in the UK suggested making sure that the outlet you are plugging into is actually properly grounded (I have had grounding problems with two houses I've lived in in the past 10 years, with both being improperly grounded, and outlets varying in their ability to cancel that 60-cycle noise). Apparently, a fair number of amps, including some famous names and models, not just yours, have insufficiently grounded power sections. Will keep looking, not much info out there, haven't even found a wiring schematic for your Bad puppy yet.
Started by Nomad Jack in Performances, How to Play, Lessons, Concerts. Last reply by J. D. Woods 11 hours ago. 7 Replies 2 Likes
Started by Moritz Voegeli in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray on Monday. 6 Replies 1 Like
Started by Timothy Hunter in Other stuff - off topic, fun stuff, whatever. Last reply by Timothy Hunter Apr 10. 14 Replies 3 Likes
Started by Tom T in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Apr 9. 9 Replies 0 Likes
Started by Southern Ray in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Apr 4. 7 Replies 1 Like
Started by Timothy Hunter in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Mar 27. 1 Reply 2 Likes
Started by Taffy Evans in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Mar 10. 1 Reply 3 Likes
Started by Cigar Box Nation in Feature Articles. Last reply by BrianQ. Mar 9. 4 Replies 3 Likes
Started by Ghostbuttons in Building Secrets, Tips, Advice, Discussion. Last reply by Timothy Hunter Mar 9. 5 Replies 1 Like
Started by Justin Stanchfield in Building Secrets, Tips, Advice, Discussion. Last reply by Taffy Evans Mar 8. 6 Replies 0 Likes
Started by Ken I in Building Secrets, Tips, Advice, Discussion. Last reply by Brian partington Mar 8. 8 Replies 0 Likes
Started by Southern Ray in Cool gear discussion - that's not cigar box related. Last reply by Southern Ray Mar 6. 5 Replies 0 Likes
Started by Taffy Evans in Other stuff - off topic, fun stuff, whatever. Last reply by Taffy Evans Mar 5. 4 Replies 2 Likes
Started by Justin Stanchfield in Building Secrets, Tips, Advice, Discussion. Last reply by Carl Floyd Mar 1. 15 Replies 0 Likes
Started by Joe in Performances, How to Play, Lessons, Concerts. Last reply by Carl Floyd Feb 29. 13 Replies 0 Likes
Started by Chance in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Feb 22. 12 Replies 1 Like
Started by Cigar Box Nation in Feature Articles. Last reply by Southern Ray Feb 21. 2 Replies 4 Likes
Started by Brad in Cool gear discussion - that's not cigar box related. Last reply by Southern Ray Feb 19. 6 Replies 3 Likes
Started by Jacob Shook in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Feb 16. 10 Replies 0 Likes
Started by Southern Ray in Performances, How to Play, Lessons, Concerts. Last reply by Southern Ray Feb 16. 2 Replies 0 Likes
Posted by Vlad on March 31, 2024 at 11:48pm 0 Comments 1 Like
Posted by Vlad on March 6, 2024 at 2:32am 5 Comments 2 Likes
Posted by billy jones bluez on February 28, 2024 at 2:09pm 0 Comments 0 Likes
Posted by billy jones bluez on February 17, 2024 at 11:00pm 0 Comments 0 Likes
Posted by Vlad on February 11, 2024 at 1:06am 1 Comment 1 Like
May 11, 2024 from 11am to 8pm – Speakeasy Grill
0 Comments 0 Likes© 2024 Created by Ben "C. B. Gitty" Baker. Powered by
Cigar Box Nation is presented by C. B. Gitty Crafter Supply, your one-stop-shop for Cigar Box Guitar parts and accessories!