Replies to This Discussion

Permalink Reply by Tom T on August 11, 2019 at 12:09pm

My experience is that Piezos are very inconsistent in the noise department. I've used some that are very quiet and others (in the same type circuit) be very buzzy. Can't say I know why.

One thing I did notice is that a Piezo will be noisy with a low quality cord. A decent triple insulated cord seems to work best and not cost an arm and a leg.

The other thing is the amp. Some amps are noisy with a piezo but quiet with a humbucker.

Odd as it sounds, try getting the hum going and reach down and touch the metal of the output jack. It may immediately get quiet. If so, then ground the strings might help since your fingers will be in contact with the strings most of the time.

It really comes down to methodologically determining what make the hum worse or better, then using that info to improve the guitar. 

Try some of the above and see what you can learn.

• ▶ Reply

Permalink Reply by Brent Kasl on August 11, 2019 at 1:06pm

I have two piezos wired, is it possible one could cause this?

• ▶ Reply

Permalink Reply by KOOL DOG HOOCH on August 11, 2019 at 11:34pm

Try a temporary placement of a.001uf cap across the jack or pot and see if that helps, that is if grounding the strings doesn't work. You may lose a little of the hi's, but you will eliminate a lot of trash noise.

• ▶ Reply

Permalink Reply by Paul Craig on August 13, 2019 at 6:46am

Check all the solder joints for good solder flow, if they have a gobbed appearance they aren't good. Could also be your cord.

• ▶ Reply