Looking for suggestions on how to improve the distance between the tail piece and bridge location.
Right now due to length of Box and 24.75" scale, the bridge is positioned about 3" from edge of box then the tailpiece is extended another 2" holding the three ferrules.
Tags:
What do you mean by "improve"?
Do you want the bridge closer to the edge or closer to the center of the box?
Does the neck have a separate fret board? Is it fretted of a slider?
Is the neck notched for the box lid?
A photo could answer a lot of questions.
photo below
The yellow tape line shows bridge position
Still not clear on what the chief concern is.
Is the bridge angle so low that the guitar doesn't play correctly?
If you want a greater angle from the tailpiece to the bridge (without raising the bridge) then you could cut the top of the tailpiece down so the brass rivets sit lower relative to the bridge, thus increasing the angle. On the other hand, if it plays okay, don't worry about it. Increasing downward force is not going to drive a cigar box top much more that it is currently. So if the objective is increased volume, it may be a lot of work for little gain.
Take a look at a hard-tail bridge and you'll see that there is really no bridge angle or down force, but hey are used commonly.
Bridge to box edge about 3" then the tailpiece as shown is about 2" and due to that length it is very low angle to the bridge
Is your fretboard flush with the box? If so, that's the real problem.
If it helps the angle enough the easiest thing would be three new string holes close to the box
Hi Brent, as I have mentioned before a simple line drawing before one starts building will help plan bridge position, neck set and break angle. Anyway................
If more angle is needed behind the bridge I would put a device, be it wood, brass, rod or flat, fitted where the two screws are with screw caps [using those two screws] behind the bridge on the edge of the lid, and run the strings under it - or through holes - and then to the bridge. Think string trees that would normally go on a peghead for the same reason.
Taff
Hi Brent, just wondering if you had a chance to address this, if so how you fixed your problem.
Taff
Finishing up an Alec Bradley American Box first with black dyed neck, chrome tuners, pickup and bridge, and walnut fretboard, then will most likely guide the strings on the build in question under a rod or screw held in place by two eyescrews then up towards bridge as mentioned. Should work fine, thanks
Thanks Brent, your new build sounds interesting.
I 'm surprised I received an email saying you had responded with in an hour??? I usually get informed next day if at all when people post. I hope that keeps up.
Taff
Started by J. D. Woods in Performances, How to Play, Lessons, Concerts. Last reply by J. D. Woods 6 hours ago. 3 Replies 0 Likes
Started by Southern Ray in Other stuff - off topic, fun stuff, whatever. Last reply by A.D.EKER yesterday. 4 Replies 0 Likes
Started by Rich Butters in Building Secrets, Tips, Advice, Discussion. Last reply by Crazed Fandango on Tuesday. 4 Replies 0 Likes
Started by J. D. Woods in Performances, How to Play, Lessons, Concerts. Last reply by J. D. Woods on Saturday. 7 Replies 1 Like
Started by Nomad Jack in Performances, How to Play, Lessons, Concerts. Last reply by J. D. Woods Apr 17. 7 Replies 2 Likes
Started by Moritz Voegeli in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Apr 14. 6 Replies 2 Likes
Started by Timothy Hunter in Other stuff - off topic, fun stuff, whatever. Last reply by Timothy Hunter Apr 10. 14 Replies 3 Likes
Started by Tom T in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Apr 9. 9 Replies 0 Likes
Started by Southern Ray in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Apr 4. 7 Replies 1 Like
Started by Timothy Hunter in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Mar 27. 1 Reply 2 Likes
Started by Taffy Evans in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Mar 10. 1 Reply 3 Likes
Started by Cigar Box Nation in Feature Articles. Last reply by BrianQ. Mar 9. 4 Replies 3 Likes
Started by Ghostbuttons in Building Secrets, Tips, Advice, Discussion. Last reply by Timothy Hunter Mar 9. 5 Replies 1 Like
Started by Justin Stanchfield in Building Secrets, Tips, Advice, Discussion. Last reply by Taffy Evans Mar 8. 6 Replies 0 Likes
Started by Ken I in Building Secrets, Tips, Advice, Discussion. Last reply by Brian partington Mar 8. 8 Replies 0 Likes
Started by Southern Ray in Cool gear discussion - that's not cigar box related. Last reply by Southern Ray Mar 6. 5 Replies 0 Likes
Started by Taffy Evans in Other stuff - off topic, fun stuff, whatever. Last reply by Taffy Evans Mar 5. 4 Replies 2 Likes
Started by Justin Stanchfield in Building Secrets, Tips, Advice, Discussion. Last reply by Carl Floyd Mar 1. 15 Replies 0 Likes
Started by Joe in Performances, How to Play, Lessons, Concerts. Last reply by Carl Floyd Feb 29. 13 Replies 0 Likes
Started by Chance in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Feb 22. 12 Replies 1 Like
Posted by Vlad on March 31, 2024 at 11:48pm 0 Comments 1 Like
Posted by Vlad on March 6, 2024 at 2:32am 5 Comments 2 Likes
Posted by billy jones bluez on February 28, 2024 at 2:09pm 0 Comments 0 Likes
Posted by billy jones bluez on February 17, 2024 at 11:00pm 0 Comments 0 Likes
Posted by Vlad on February 11, 2024 at 1:06am 1 Comment 1 Like
May 11, 2024 from 11am to 8pm – Speakeasy Grill
0 Comments 0 LikesMay 30, 2024 from 6:30pm to 10pm – The Casual Pint of Huntsville
0 Comments 0 Likes© 2024 Created by Ben "C. B. Gitty" Baker. Powered by
Cigar Box Nation is presented by C. B. Gitty Crafter Supply, your one-stop-shop for Cigar Box Guitar parts and accessories!