Replies to This Discussion

Permalink Reply by darryl kernaghan on June 24, 2018 at 7:44pm

Wes, you say your bridge is set the same for all strings, I take that to be both height and length, generally the scale will get marginally longer going from top [thinnest] to lower, I,d suggest tuning and adjusting the bridge until you get the low string hitting a g at both open and at the 12th fret, which will probably mean setting the individual bridge section back 2 or 3 mm, when you've done that it might be worthwhile to do the same with the d string, as in my experience they are never exactly the same scale length as the others.

• ▶ Reply

Permalink Reply by Cause the Blue rat on June 24, 2018 at 10:07pm

Totally agree with Darryl. If you have a tuner you can us it to set your bridge intonation. Set each string. Worst case you may have to move the bridge if your that far off. 

There are lots of great how to vids on youtube for setting up a bridge. 

• ▶ Reply

Permalink Reply by Timothy Hunter on June 24, 2018 at 10:56pm

Gitty has a setup guide here

https://www.cigarboxguitar.com/knowledge-base/how-to-use-hard-tail-...

what needs to be the same is the harmonic at the 12th fret and the string fretted at the 12th fret. then if the frets are correct and the action not too high then it should be in tune all up and down the fretboard. 

• ▶ Reply

Permalink Reply by Kirk on June 25, 2018 at 2:08am

Most likely it's your string height at the nut.  If you're not playing slide, then you want it to be about the thickness of a business card between the fret and the string. 

• ▶ Reply

Permalink Reply by Taffy Evans on June 25, 2018 at 10:46am

Hi, I would not discount a bad string, I've had that a few times, swap it to test. Also check that the nut is parallel to the first fret.

Taff

• ▶ Reply

Permalink Reply by Wes Williams on June 25, 2018 at 9:48pm

Thanks you all for your advice. I’ve adjusted the bridge height and it’s ALMOST right, so I think that’s been my main problem. I also think my nut height is too high. A business card, huh? Mine’s more like a stack on business cards, but I’ve developed some killer calluses playing with such high action. I plan to file the nut down today to reduce that action.

I had not considered a bad string. If I can’t get a good result with the nut height I’ll give that a try.

Again, thank you all for your help.

MangoDoc

• ▶ Reply

Permalink Reply by Kirk on June 26, 2018 at 4:02am

You could probably get away with about the thickness of a hard pick.  I remember Glenn Watt having a video where he said three playing cards.  So a business card might be too thin.  If you like a high action, file down the nut, or nut slot until it doesn't got too sharp when you fret. 

• ▶ Reply