Replies to This Discussion

Permalink Reply by Rob on March 31, 2016 at 4:15am

O yeah, building a silent resonator guitar .... ;-) btw i am talking about the cover plate .....

• ▶ Reply

Permalink Reply by Rob on March 31, 2016 at 5:57pm

Well i like both ways. A clean built with a decent box in combinnation with the right timber for fretboard looks also very nice.

But, i also like the "used" look. My 2nd project at the moment is licencense plate CBG. And as you can see below the plate is definitly in used condition and the timber for the box is from an old palette. Looking for rusty screws and nails at the moment ...

Attachments:

• 015.JPG, 1.2 MB
• 014.JPG, 1.2 MB

• ▶ Reply

Permalink Reply by Rob on March 31, 2016 at 6:03pm

Thanks, for answering. Seems than pretty much ok with .031 or slightly thicker. And if it gets some dings and dongs over the time, thats no problem for me - thats life.

• ▶ Reply

Permalink Reply by Randy S. Bretz on March 31, 2016 at 11:59pm

I made mine from a piece of 1/2" black walnut, carved it dome shape.

• ▶ Reply

Permalink Reply by Tom T on April 1, 2016 at 12:21am

0.031" copper is pretty thin to resist flexing. You could use the copper to cover a 1/8" masonite base, it should hold up well and look very good.

I built a wooden resonator cover for mine that came out pretty good. That too is an option.

• ▶ Reply

Permalink Reply by Bluesheart on April 2, 2016 at 8:09am

That is beautiful work!!

• ▶ Reply

Permalink Reply by Tom T on April 2, 2016 at 8:27am

Thanks,

I kept trying different designs until I got something I liked. I'm working on a copper bridge cover/palm rest. That will make playing a little easier.

• ▶ Reply

Permalink Reply by Michael Fred Johnson on April 1, 2016 at 3:44am

That's more than thick enough,it's not going to take any load.This guitar front is 0.66 thick,planished with a polished faced hammer,both to change the appearance and work harden the copper.

• ▶ Reply

Permalink Reply by Tom T on April 1, 2016 at 6:56am

If you build a bridge cover as is often seen on resonator covers, then there will be some downward pressure on the cover caused by your palm resting on the bridge cover. If you do not build the bridge cover, then there is effectively nothing pressing on the reso cover so 0.031" should hold up.

• ▶ Reply

Permalink Reply by Rob on April 1, 2016 at 7:06am

I am not sure, but maybe yes. I will decide when the guitar build is finished. But good point to consider.

• ▶ Reply

Permalink Reply by Bluesheart on April 2, 2016 at 8:10am

Amazing work on that!!!

• ▶ Reply

Permalink Reply by Michael Fred Johnson on April 1, 2016 at 6:44am

The process you are describing is annealing which makes the copper softer and easier to work,more malleable.

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page