I wanted to run the Roland Cube 10GX amplifier by a battery for my cigar box guitar.

As with most Roland stuff, this amp has some great tones, will get very loud and costs $129. The Roland Cube 10GX is normally powered by a 5.7 volt DC/120 volt [USA] wall transformer.

I have been powering my guitar pedals, small mixer, and Roland Micro Cube amps with LiPo batteries that are primarily used for Radio Controlled electric motors. The small LiPo batteries come in multiples of a specified voltage of 3.7 volts per cell and have to be charged with a LiPo battery charger. The cells are actually charged to 4.2 volts. I have never found an explanation for why LiPo batteries are specified at 3.7 volts per cell.

Anyway, I have been using a two cell, 2.2 amp-hour LiPo battery, charged to 8.2 volts to power my 9 volt guitar stuff and all seem to work fine. This is very economical since the batteries can be charged over 1000 times, are not very expensive and have several times the capacity of a regular 9 volt disposable battery. I think a typical 9 volt non-rechargeable battery has about 0.5 amp-hour capacity.

I recently bought a Roland Cube 10RX hoping to power it with one of my LiPo batteries. Well, a 4.2 volt battery is too low and a 8.2 volt battery is too high. I discovered a "DROK LM2596 adjustable voltage regulator" that would reduce the 8.2 volts or any other DC voltage up to 40 volts, to the 5.7 volts DC required by my Roland Cube 10RX. So, it could be used with any 12 volt battery and can handle up to 2+ amps. There are other voltage regulators out there that can handle more than 2 amps, if you need it. Also, the regulator has a digital readout to show either input voltage or output voltage which is also handy.

To connect the battery to the voltage regulator I used a battery connector with pig tails. If you were not going to use the battery for other stuff, you could cut off the battery connector and connect the battery wires directly to the voltage regulator. I ordered a 2.1mm power connector that fit the amp with pigtails. Connect the battery to the "In" of the voltage regulator and the 2.1mm connector to the "Out" of the voltage regulator. Plug the battery in and adjust the output voltage with the little adjusting screw.

I haven't decided how to attach the battery and regulator to the back of the amp. Maybe just Velcro or stuff in a bag and hang from the back.

My Roland Cube 10GX is the loudest, best sounding battery powered guitar amplifier I have yet discovered. It is a 10-watt guitar amp with custom-designed 8" speaker Three preset COSM amp types: Clean, Crunch, and Lead which can be replaced with 10 other custom COSM amps via the free CUBE KIT app for iOS and Android devices.

Views: 3007

Attachments:

Reply to This

Replies to This Discussion

Sounds like a great solution for a lot of applications. The data sheet for the LM2596 makes it sound pretty easy to set up. Does it need a heat sink?

Tom,

No heat sink is needed for powering the Roland 10GX. My voltage regulator doesn't even get warm. It's the "Buck" type which is pretty efficient.

The voltage regulator came assembled on the circuit board. They are very inexpensive on Ebay.

I do use the LIPo's for a lot of applications. They make round ones that look like could be directly substituted for round batteries. I haven't gotten one of those. I already had all of this stuff from RC electric flying.

The chargers are a little investment. I got a nice USA made cell balancing one 5 years ago. I think a good one can be had for $30. The battery savings are remarkable.

I see what you mean by inexpensive.......

Under $5.00 including shipping on ebay. And that includes a digital voltage readout. That's just amazing.

A small wet cell motorcycle battery should keep you playing for days without a recharge.

I used to fly RC planes so I am familiar with those battery packs and the charger. Still have it in a box some place.

Thanks for all the useful information.

Here is the ebay listing link Voltage Reg

$2.88 including shipping?!?! What could this stuff cost to build? Shipping is at least $1.50 even on a Chinese Junk. These prices scare me..........

There's no question that this type of device (variable output) is a great idea. How many different devices do you have that each need a different voltage (5.7, 9, 12, 17, etc, etc etc). With the Amp rating, it could power a lot of stuff.

See, there you go, directing me back to ebay "just in case"....

this is why I love this hobby and board, necessity is still the mother of invention, and so many great things are begun with the question "Well why couldn't I...?)  great stuff and ideas to stay busy for years.. thanks!

Beauty just ordered 2 cheaper than a cup of coffee, thanks for sharing.

                            Cheers Ron

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building Basics

Site Sponsor

Recommended Links & Resources


Forum

crossover guitar.

Started by Timothy Hunter in Other stuff - off topic, fun stuff, whatever. Last reply by Timothy Hunter Mar 21. 11 Replies

Tune up songs

Started by Ghostbuttons in Building Secrets, Tips, Advice, Discussion. Last reply by Timothy Hunter Mar 9. 5 Replies

Duel output jacks

Started by Justin Stanchfield in Building Secrets, Tips, Advice, Discussion. Last reply by Taffy Evans Mar 8. 6 Replies

How to Get Your Own Music on Spotify

Started by Cigar Box Nation in Feature Articles. Last reply by Southern Ray Feb 21. 2 Replies

CB Bass Guitar

Started by Mi Rankin in Building Secrets, Tips, Advice, Discussion. Last reply by Justin Stanchfield Jan 27. 5 Replies

Latest Activity

A.D.EKER commented on Dar Stellabotta's video
Thumbnail

A Cigar Box Guitar Six Stringer Built by Louie Lamanna

"i See Your ready to Blow away the GRAND STADIUM ! tree strings more of DAR DELIGHT !! Shine Girl !…"
3 hours ago
A.D.EKER commented on A.D.EKER's video
Thumbnail

Im Troubled (Tribute) Mc K Morganfield by BCB - A.D .Eker 2024.

"Thank you for the kind comments Doug! Glad you liked the Picture !"
3 hours ago
BrianQ. commented on Dar Stellabotta's video
7 hours ago
BrianQ. liked Dar Stellabotta's video
7 hours ago
Southern Ray commented on Southern Ray's photo
Thumbnail

Project Punch!

" Thank ya again Keith!"
10 hours ago
Southern Ray commented on Southern Ray's photo
Thumbnail

Punch Project!

" Thank Ya Keith!"
10 hours ago
Doug Thorsvik commented on AGP #'s photo
Thumbnail

AGP #527 - ''Led-Zep 2''

"This build really strung you along Alan! Reminded me of all my fishing line experiments; a lot of…"
11 hours ago
Doug Thorsvik commented on A.D.EKER's video
Thumbnail

Im Troubled (Tribute) Mc K Morganfield by BCB - A.D .Eker 2024.

"Diggin’ the slow blues. I like that last pic Andries! Look at all those cool guitars. Yeah!!!"
11 hours ago
Dar Stellabotta posted a video

A Cigar Box Guitar Six Stringer Built by Louie Lamanna

This video is the unboxing and the demonstration of a beautiful, six stringer built by Louie Lamanna. Join Louie and I June 15 at the second annual Pittsburg...
13 hours ago
Doug Thorsvik commented on Doug Thorsvik's video
Thumbnail

Hail the Resurrection Day: 2-String Violin Chugger Cigar Box Guitar

"Happy Easter to you too Andries! The passion is definitely in full swing. Turns out I’m…"
13 hours ago
A.D.EKER commented on Doug Thorsvik's video
Thumbnail

Hail the Resurrection Day: 2-String Violin Chugger Cigar Box Guitar

"Happy Easter Doug ! the Passion is in full swing !"
14 hours ago
A.D.EKER commented on Ricky D's photo
14 hours ago

Music

© 2024   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->