Comment

Comment by Bad Finger (Eric) on December 4, 2014 at 7:12am

OK, we are just a little out of synch, but getting closer.  Just working on the note C, move your tenth fret D string and 3rd fret A string to the left one octave.  The C that is one line below the staff.

Comment by Bad Finger (Eric) on December 4, 2014 at 7:09am

All those lines. . . 

Low D string 10th fret is the same note as A string 3rd fret.  Same octave, same frequency, just a different location on the fretboard.  Your orange lines should point to the same note, not different notes.

Comment by BUGGY (C) on December 4, 2014 at 7:09am

so what happens to the high strings? where do they show in a score?

Comment by Bad Finger (Eric) on December 4, 2014 at 7:06am

Still off, I think.  I think you are one octave too high on your music staff compared with your fretboard.

Middle C is:

low D string 10th fret

A string 3rd Fret

The second C on the music staff reading from left to right.

Comment by BUGGY (C) on December 4, 2014 at 7:04am

Still cant get it to work? is that because some strings are duplicates rather than chromatic ?

Comment by BUGGY (C) on December 4, 2014 at 6:53am

Comment by BUGGY (C) on December 4, 2014 at 6:50am

Ok ta think I have got it will tweak diag hang on a sec

Comment by Bad Finger (Eric) on December 4, 2014 at 6:47am

Assuming you are using EADG strings from a six pack, your higher D string (between A and F#) is one step above middle C. Middle C would be the 3rd fret on your A string.  My memory on this is weak, but using it anyway, in conjunction with your graphics, it appears you have labeled the left hand graphic one octave too high compared with your guitar fretboard.

Comment by BUGGY (C) on December 4, 2014 at 6:38am

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page