Comments

• 

  James May 4, 2013 at 11:19am

  see Reeds Taylors design,  another way to build one maybe easier than i have shown you !!

  http://www.cigarboxnation.com/photo/cbg-neck-through-design
• 

  Ted Hartman May 3, 2013 at 3:31pm

  fret wire  C.B. Gitty Crafter Supply.!!!!
• 

  James May 1, 2013 at 10:19pm

  fretboard is added to top of neck . not depicted in picture  
• 

  James May 1, 2013 at 10:18pm

  
• 

  James May 1, 2013 at 10:16pm

  
• 

  James May 1, 2013 at 8:45pm

  

   all these were 1 1/2 x  1 1/2 x 36 they are one piece, meaning the heal is integrated, the piece of wood you see on the bottom inside the box is just to reinforce   where the neck was cut deep for the pickup to clear , again good luck with your project !!!
• 

  James May 1, 2013 at 8:22pm

  http://www.cigarboxnation.com/photo/build-4-copy/next?context=user

   last link was just my page sorry, here is another example 
• 

  James May 1, 2013 at 8:18pm

  http://www.cigarboxnation.com/photo/guitar-4a?context=user   this is a 1 1/2 " x1 1/2"  2x2 

   x36 like you are talking about, i used a table saw and a jigsaw to cut  this, using table saw with dado blade to remove inside material, and jig saw carefully to do curves,  much better than using a 3/4 stock, stronger , http://www.cigarboxnation.com/profile/James184,  good luck !!!    many ways to do it