Gender
Male
Gender
Male
Location
Auckland
Birthday:
September 22
What would be a good test of pieces of timber..to determine suitability and best use for a neck and fretboard? I have three great large pieces of timber (planks) from which I can mill and machine a few necks and a few fretboards. Now I have many…
Read more…To those of you that overlap your fret board onto the top of the box.(the lid) ..are you leaving a gap at all? I have been puzzling out this part of the design and have most of it figured except if I should leave a gap or not. The neck will run…
Read more…Been looking with no luck so far What is the optimum or recommended height of the strings to the Fret... at 1st and last fret? This is determined by nut and bridge ..which I want to think about for design purposes.
Read more…Let the fun begin! I hope that I may create this as a project thread where I can track my project build as well as get advice and tap into all of your considerable experience and awesome ideas on the way. Plan is to research this forum thoroughly…
Read more…