Hi everyone,
I'm new here to CBN and new to CBG making. I've made 4 so far. I am planning to make a pickup. So far I have been using piezos, which do the job fine if you can keep the feedback to a minimum. But I like making things from scratch and I have a little bit of electronics experience. I've seen plenty of vids on how to make single coils and then in my research came across the Original Flatpup and I was really intrigued. So I just have some questions some of you might be to help me with. Is the same length of wire used to wind both sides or is it two separate lengths of wire? This leads me to my next question. If it is two separate lengths of wire, one for each side, is one side the hot and the other the ground? I hope that doesn't show my ignorance to much and thanks in advance.
JL
so the simple idea is... magnet in the center, pole pointing up, start winding the first coil forward to one side of the magnet, then continue winding backwards the same amount to the other side.
noise cancellation occurs because the windings on either side go in opposite directions, and because the magnetic lines of force are also going in opposite directions on each side the induced charges add instead of subtract.
Feb 2, 2017
john mackay
this what oily was referring to........
http://www.cigarboxnation.com/forum/topics/joes-flatpickup
Feb 2, 2017
Christopher G Daniels
Oct 11, 2021