Comment

Comment by smilingdog1 on December 4, 2014 at 4:07pm

The results I get between the smaller to large diaphragm is slight tone using exact same harness for comparisons. I find the positioning of the disc to be #1 importance in volume & tone and try a 500K pot. I recommend trying out a 25 buck BEHRINGER PREAMP/BOOSTER PB100.

This little preamp gets amazing results and you can adjust bass/treble/gain.

Comment by Slow Slough Guitars on December 4, 2014 at 3:30pm

Is there any advantage/disadvantage to using a 27 mm piezo vs a 20 mm disc?

Comment by Thomas "Duck" Petry on November 10, 2013 at 6:57pm

Looks like tree wood. :)>

Comment by Ryan Russell on November 10, 2013 at 3:36pm

Very Nice. Used The Same Box For A Diddley Bow A Couple Months Ago.

Comment by Habanera Hal on July 11, 2013 at 4:40am

Randy -

What kind of wood is that fingerboard?

Comment by Bruce Trappes on July 10, 2013 at 11:45pm

That fret board matches the box beautifully. There's something very refreshing about nice clean lines.

Comment by Randy S. Bretz on July 10, 2013 at 10:13pm

In the works...mag rail / flush fret

Comment by smilingdog1 on February 25, 2013 at 9:29am

Out of a thousand posted diagrams/schematics on how to do, I'd say five are descent and one superb in any category. Everybody has a different method of receiving information. I've heard and seen many great ideas, and understood very few in detail. I'm working on some how to videos that will be ready and up by summer. I'll post them with the invite to criticize and hopefully promote revised methods of sharing shop techniques I've picked up. Anyway it would be nice to have a how to video library on site that you type in your search and pull up what you're looking for. As it is, you type in search and get dozens of unrelated topics. Any feedback to this?

Comment by Charlotte Henry on January 8, 2013 at 7:01pm

Thought this may be of interest to some of you. http://www.csgnetwork.com/righttricalc.html

I am using a neck block with a bolt on neck and am routing the slot for the neck with the 1 degree angle built in and this showed me that I could put a 1 degree pitch in the neck on an 11 inch box by lifting the tail end with a .19 inch shim when on the router table. 

Comment by ChickenboneJohn on August 12, 2012 at 6:51pm

If you want resonator cone & coverplate sets, I've got "Continental" uke sets n stock..contact me for prices & shipping.

• ‹ Previous
• 1
• 2
• 3
• 4
• …
• 18
• Next ›
• Page