Hi everyone! I'm attempting to make my first diddley bow, and was following the directions from One String Willie

Everything's fine so far, except I have .056 gauge music wire, and it is VERY stiff and heavy. I have just some el cheapo tuning machines, and I'm not sure they'll stand up to this. I've never built my own instrument before and I'm sort of nervous.

Any advice? Will that heavy of a wire work, or should I just give up and get a guitar string? Also, I see Dr. Oakroot's directions say you can use fishing line - anyone know how good that sounds?

Thanks!
Pam

Views: 345

Replies to This Discussion

I'd go for the music wire. You don't even need tuning machines for a diddley bow-just 2 nails or wood screws. Tighten the string between these as tight as possible and then jam something(bottle, wood, metal etc) on each end of the string to form a bridge and a nut.
Wade, thanks for the advice. Since I had the materials, I'm going to make two of them - I'll use the heavy music wire like you suggested for one, and then a lighter wire and the tuning machine on the other. When I get 'em done, I'll post pics.
Hi Pam-

I use 0.056 music wire on some of my diddley bows, and as Wade says, you don't necessarily need tuning machines, just a couple of 16 penny nails driven well into the wood. Put the diddley bow on the floor, put the music wire beside one of the nails, and position yourself with your left hand on the long part of the wire to hold it down. Lean down to put your wieght on your hand and the wire, and with long-nosed pliers in your right hand, wrap the wire around the nail twice. It is easiest to do this if you are working with your torso right above the diddley bow with the nail pointing at you, rather than working from the side. You get a lot more leverage on the wire that way. After you have a little more than two wraps, insert the pliers under the long part of the wire, grab the short end of the wire with the tips of the pliers and pull it under the long part, and then fold the short end of the wire over the long part to lock it in place.

So, the wire has two wraps going UP the nail, and then the short end is pulled UNDER the long end and is folded over the long end to lock it in place.

Repeat this at the other nail. I would advise hammering a finishing nail next to the 16 penny nail and hammering down over the wire to prevent it from riding up the nail when you slip the bridge and nut under the wire.

You can try fishing line, but my feeling is that it would likely be much too flimsy to hold up to the kind of playing I do. However, you may find a different way of playing that would work well with this kind of string. For example, Lonnie Pitchford played a guitar-like diddley bow and his playing style featured multiple pull-offs (two or three fingers pulling off in rapid sequence) and hammer-ons, and this type of string would probably be well suited for that type of playing style.

Please let me know how it comes out--since you are following my instructions, I have a particular interest in making sure the instructions are clear, and that you are happy with your instrument!

Good luck and please let us know how it works out!

Best regards, Willie
Wow, thanks for the advice! I really enjoyed your site, and appreciate your personal reply. I have to say that I am just flat out scared of that .056 wire! It's a real beast to work with, so I'll try to enlist some help and follow your tips. And wear good eye protection!!

I've finished the lighter version w/the tuning machine and it sounds pretty good. I tried the fishing line and it didn't have much oomph - although when I shoved an Altoids tin next to the "bridge" it was an interesting effect. But not what I wanted, so I swapped the fishing line out with a guitar string (.032) and I like the sound a lot.

One String Willie said:
Hi Pam-

I use 0.056 music wire on some of my diddley bows, and as Wade says, you don't necessarily need tuning machines, just a couple of 16 penny nails driven well into the wood. Put the diddley bow on the floor, put the music wire beside one of the nails, and position yourself with your left hand on the long part of the wire to hold it down. Lean down to put your wieght on your hand and the wire, and with long-nosed pliers in your right hand, wrap the wire around the nail twice. It is easiest to do this if you are working with your torso right above the diddley bow with the nail pointing at you, rather than working from the side. You get a lot more leverage on the wire that way. After you have a little more than two wraps, insert the pliers under the long part of the wire, grab the short end of the wire with the tips of the pliers and pull it under the long part, and then fold the short end of the wire over the long part to lock it in place.

So, the wire has two wraps going UP the nail, and then the short end is pulled UNDER the long end and is folded over the long end to lock it in place.

Repeat this at the other nail. I would advise hammering a finishing nail next to the 16 penny nail and hammering down over the wire to prevent it from riding up the nail when you slip the bridge and nut under the wire.

You can try fishing line, but my feeling is that it would likely be much too flimsy to hold up to the kind of playing I do. However, you may find a different way of playing that would work well with this kind of string. For example, Lonnie Pitchford played a guitar-like diddley bow and his playing style featured multiple pull-offs (two or three fingers pulling off in rapid sequence) and hammer-ons, and this type of string would probably be well suited for that type of playing style.

Please let me know how it comes out--since you are following my instructions, I have a particular interest in making sure the instructions are clear, and that you are happy with your instrument!

Good luck and please let us know how it works out!

Best regards, Willie
Hi Pam-

Thank you for your kind words!

I agree that the 0.056" wire is a pain to bend and to cut. Heavy pliers are needed to cut wire this thick and hard. Broom wire is approximately 0.045" (18-1/2 gauge) and is much easier to work with. I am trying to get a supply of broom wire that I can make available from my website.

I will keep you posted.

Best regards, Willie

Pamster said:
Wow, thanks for the advice! I really enjoyed your site, and appreciate your personal reply. I have to say that I am just flat out scared of that .056 wire! It's a real beast to work with, so I'll try to enlist some help and follow your tips. And wear good eye protection!!

I've finished the lighter version w/the tuning machine and it sounds pretty good. I tried the fishing line and it didn't have much oomph - although when I shoved an Altoids tin next to the "bridge" it was an interesting effect. But not what I wanted, so I swapped the fishing line out with a guitar string (.032) and I like the sound a lot.

One String Willie said:
Hi Pam-

I use 0.056 music wire on some of my diddley bows, and as Wade says, you don't necessarily need tuning machines, just a couple of 16 penny nails driven well into the wood. Put the diddley bow on the floor, put the music wire beside one of the nails, and position yourself with your left hand on the long part of the wire to hold it down. Lean down to put your wieght on your hand and the wire, and with long-nosed pliers in your right hand, wrap the wire around the nail twice. It is easiest to do this if you are working with your torso right above the diddley bow with the nail pointing at you, rather than working from the side. You get a lot more leverage on the wire that way. After you have a little more than two wraps, insert the pliers under the long part of the wire, grab the short end of the wire with the tips of the pliers and pull it under the long part, and then fold the short end of the wire over the long part to lock it in place.

So, the wire has two wraps going UP the nail, and then the short end is pulled UNDER the long end and is folded over the long end to lock it in place.

Repeat this at the other nail. I would advise hammering a finishing nail next to the 16 penny nail and hammering down over the wire to prevent it from riding up the nail when you slip the bridge and nut under the wire.

You can try fishing line, but my feeling is that it would likely be much too flimsy to hold up to the kind of playing I do. However, you may find a different way of playing that would work well with this kind of string. For example, Lonnie Pitchford played a guitar-like diddley bow and his playing style featured multiple pull-offs (two or three fingers pulling off in rapid sequence) and hammer-ons, and this type of string would probably be well suited for that type of playing style.

Please let me know how it comes out--since you are following my instructions, I have a particular interest in making sure the instructions are clear, and that you are happy with your instrument!

Good luck and please let us know how it works out!

Best regards, Willie

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building Basics

Site Sponsor

Recommended Links & Resources


Discussion Forum

Let’s talk Dorian… for Diddley bow’s in G & D

Started by BrianQ.. Last reply by Cliff Whitefoot Mar 30, 2022. 1 Reply

Finger stretching exercise - Diddley Bow

Started by BrianQ.. Last reply by BrianQ. Mar 12, 2022. 2 Replies

One String Wonder

Started by BrianQ. Jan 29, 2021. 0 Replies

Bridges

Started by Ken Thompson Nov 27, 2020. 0 Replies

Diddley Bow Tabs #5

Started by BrianQ. Apr 22, 2019. 0 Replies

Diddley Bow Tabs #4

Started by BrianQ. Jan 25, 2019. 0 Replies

Diddley Bow Tabs #3

Started by BrianQ. Nov 28, 2018. 0 Replies

1 String Tab

Started by BrianQ.. Last reply by BrianQ. Nov 15, 2018. 1 Reply

Diddley Bow Tabs #2

Started by BrianQ. Nov 8, 2018. 0 Replies

Diddley Bow Tabs

Started by BrianQ. Nov 4, 2018. 0 Replies

Dead Flowers Diatonic Tab for Rolling Stones fans

Started by Jeff Powers. Last reply by Jeff Powers Oct 5, 2017. 2 Replies

Cookie Tin Diddley Bow

Started by Jeffrey Greene May 12, 2017. 0 Replies

First stringed instrument build!

Started by Bob. Last reply by Bob Apr 30, 2017. 3 Replies

My first Diddley-Bow!

Started by Boris Timofeenko. Last reply by Dano Schultz Apr 23, 2017. 2 Replies

String For My First Diddley Bow

Started by Jeffrey Greene Apr 11, 2017. 0 Replies

Showing off my first Diddley Bow.

Started by Andrew Cooper. Last reply by Andrew Cooper Mar 11, 2017. 2 Replies

Harmonica tab to Diddley bow/Canjo

Started by James Conder. Last reply by Gordon Cooper Dec 6, 2016. 1 Reply

My double stringer

Started by Craig Simpson Nov 14, 2016. 0 Replies

Latest Activity

A.D.EKER commented on Dar Stellabotta's video
Thumbnail

A Cigar Box Guitar Six Stringer Built by Louie Lamanna

"i See Your ready to Blow away the GRAND STADIUM ! tree strings more of DAR DELIGHT !! Shine Girl !…"
4 hours ago
A.D.EKER commented on A.D.EKER's video
Thumbnail

Im Troubled (Tribute) Mc K Morganfield by BCB - A.D .Eker 2024.

"Thank you for the kind comments Doug! Glad you liked the Picture !"
4 hours ago
BrianQ. commented on Dar Stellabotta's video
8 hours ago
BrianQ. liked Dar Stellabotta's video
8 hours ago
Southern Ray commented on Southern Ray's photo
Thumbnail

Project Punch!

" Thank ya again Keith!"
10 hours ago
Southern Ray commented on Southern Ray's photo
Thumbnail

Punch Project!

" Thank Ya Keith!"
11 hours ago
Doug Thorsvik commented on AGP #'s photo
Thumbnail

AGP #527 - ''Led-Zep 2''

"This build really strung you along Alan! Reminded me of all my fishing line experiments; a lot of…"
12 hours ago
Doug Thorsvik commented on A.D.EKER's video
Thumbnail

Im Troubled (Tribute) Mc K Morganfield by BCB - A.D .Eker 2024.

"Diggin’ the slow blues. I like that last pic Andries! Look at all those cool guitars. Yeah!!!"
12 hours ago
Dar Stellabotta posted a video

A Cigar Box Guitar Six Stringer Built by Louie Lamanna

This video is the unboxing and the demonstration of a beautiful, six stringer built by Louie Lamanna. Join Louie and I June 15 at the second annual Pittsburg...
14 hours ago
Doug Thorsvik commented on Doug Thorsvik's video
Thumbnail

Hail the Resurrection Day: 2-String Violin Chugger Cigar Box Guitar

"Happy Easter to you too Andries! The passion is definitely in full swing. Turns out I’m…"
14 hours ago
A.D.EKER commented on Doug Thorsvik's video
Thumbnail

Hail the Resurrection Day: 2-String Violin Chugger Cigar Box Guitar

"Happy Easter Doug ! the Passion is in full swing !"
15 hours ago
A.D.EKER commented on Ricky D's photo
15 hours ago

Music

© 2024   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->