Just got some parts arrived for my next build which is a VW Hubcap guitar.
The pickup I am going to fit is a single coil (sized) twin rail humbucker. Which comes with wiring that I'm not familiar with, I suspect the extra wires are for out of phase switching, but my knowledge of wiring is sketchy and limited.
My question is that my desired setup is this one pickup, with a volume and tone controls, and in and out of phase switching either by a switch or with a push pull pot.
First I really need a circuit diagram, bearing in mind that I'm not au fait with wiring symbols, and also to know wether 250 or 500k pots will be best, and will any capacitor be required and if so include this in the schematic.
I want a deeper sound with bite rather than a trebly jangle, and I will be placing the pickup in the neck position.
By the way for any of you who know of me, re the operation I had last October which unfortunately caused me to have no feeling in my right hand, I got a phone call this morning to confirm the operation date to hopefully God willing put it right, will happen on the 22nd of November, so fingers crossed.
Hope someone can help, as I have all the components for this build coming this week and I would love to get it sorted before going into hospital. I have attached a picture of the pickup wires, so thanks in anticipation.
Best Wishes
Phil Hale uk

Views: 291

Attachments:

Replies to This Discussion

Thanks for that Wayfinder, much appreciated.

From your pic, the red and blue wires twisted together are the end of the first coil and the start of the other coil, leaving white for hot and black and the bare wires for ground. This would be for typical series humbucking mode.

If you want to do a series/parallel or coil tap, then you'll need to disconnect the red and blue wires and wire them to a switch/pot. From what I'm seeing in the pic: white=hot and red would be the end of that coil/ground and the next coil would be blue=hot to black for the end of that coil/ground.

What I would suggest is wiring the pickup to a 4-way selector switch to 1 volume and 1 tone w/cap, then to the jack. Wiring the HB to that switch as 2 singles would be easy and allow you to play either coil separate, both coils together in parallel or both together in series.

Thank for that Paul. I will digest that and figure out the way forward.
Best Wishes Phil

I think I bought the same part, one pre-wired and one just the pickup. Here is the wiring diagram, hopefully without errors. I was wanting to split the coils of an old Epiphone humbucker and use this wiring.

Attachments:

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building BasicsCigar Box Guitar Parts Store

Site Sponsor

Recommended Links & Resources

Discussion Forum

Output method

Started by Holly Hodson. Last reply by Christopher G Daniels on Sunday. 3 Replies

Why have a switch?

Started by Arthur Payne. Last reply by ILL GREEN Apr 12. 3 Replies

Problem with second-hand amp.

Started by Arthur Payne. Last reply by Arthur Payne Apr 2. 5 Replies

Added the CB Gitty “Psycho Knob”

Started by Tim Pannabecker. Last reply by Paul Craig Mar 8. 16 Replies

Lipstick pickup and Telecaster neck pickup. What goes where?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Mar 1. 12 Replies

Wiring CB Gitty Black Ice Single Coil

Started by ILL GREEN. Last reply by ILL GREEN Jan 9. 5 Replies

Minimal effect from volume or tone pot

Started by Arthur Payne. Last reply by Paul Craig Dec 21, 2018. 9 Replies

Problem posting discussion

Started by Arthur Payne. Last reply by Paul Craig Dec 17, 2018. 2 Replies

Creackle from Volume and Tone pots

Started by Arthur Payne. Last reply by Arthur Payne Nov 27, 2018. 3 Replies

Vol, tone, 3 way toggle and 2 single coils?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Paul Craig Nov 25, 2018. 20 Replies

two picksups - both or separate

Started by Reynhard Boegl. Last reply by Reynhard Boegl Sep 27, 2017. 8 Replies

Psycho knob

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 4 Replies

Psycho knob install

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 13 Replies

Psycho knob

Started by bizzaro guitaro Sep 18, 2017. 0 Replies

I cheated and bought a solderless wiring harness. Naughty boy!

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Aug 18, 2017. 46 Replies

Capacitor

Started by Rose Ericson. Last reply by Rose Ericson Jul 8, 2017. 2 Replies

Wiring A Dual Rail Pickup into A Cbg

Started by Philip Hale. Last reply by Paul Craig Jun 2, 2017. 5 Replies

Buzz or maybe humm

Started by Rose Ericson. Last reply by Paul Craig Mar 12, 2017. 8 Replies

unbalanced pickups

Started by Don Tucker. Last reply by Paul Craig Dec 30, 2016. 13 Replies

Latest Activity

micky rooney replied to micky rooney's discussion aluminium bobbins
"Thank you,Brian...All interesting stuff"
30 minutes ago
BrianQ. liked Dave Lynas's video
1 hour ago
BrianQ. commented on Dave Lynas's video
Thumbnail

Ice Out

"Great video Dave, lots going on between the music & visuals, in a good way :) that fiddle…"
1 hour ago
BrianQ. commented on Uncle Gus's video
Thumbnail

To Be Cannibalized: 1976 Ovation 1132-1

"Too bad your gonna rip that thing apart, it’s an easy fix? Btw, any guitar, acoustic or…"
1 hour ago
Dennis "Denbo" Goodinson replied to Will "KOOLDOG HOOCH" Bonner's discussion Scale length for 17" box in the group Building a Cigar Box Guitar 101
"Firstly, I'm no expert, but in the absence of other advice I'll offer what I can.…"
1 hour ago
BrianQ. liked Andries D. EKER's video
1 hour ago
BrianQ. commented on Andries D. EKER's video
Thumbnail

Carry my Heavy Load A. D. Eker 2019

"Great riffin’ Andries! Lookin’ mighty sharp tho :D"
1 hour ago
BrianQ. added 2 discussions to the group CBG Tabs
1 hour ago
Daniel Walter commented on Dave Lynas's video
Thumbnail

Ice Out

"nicely put together Dave, lot going on there. is that clawhammer you're doing? love the…"
1 hour ago
T-Gripped replied to Will "KOOLDOG HOOCH" Bonner's discussion Scale length for 17" box in the group Building a Cigar Box Guitar 101
"The tendency on first builds is to overthink things. You really want it to be a wonderful build…"
2 hours ago
BrianQ. replied to micky rooney's discussion aluminium bobbins
"Here ya go Mickey, an old thread about induction pickups from another…"
2 hours ago
BrianQ. commented on Andries D. EKER's status
"Have reported the issue to Gitty?"
2 hours ago

Music

Loading…

© 2019   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->