Click PAUSE on the diagram you need then click the pic to open it in a new window.

Need a diagram not here?  Just ask.

Found at my Handmade Music Clubhouse.  


Views: 6169

Replies to This Discussion

Ted,

I'm betting it will work. It erases some nasty hum on my guitars, always. I use disks, the only thing is you will get a signal from the piezo (ok so far for me), so it will add sound unless there's a separate volume control, which could be messy. (probably not for you). Or the piezo can be buried where it won't add to the signal. Best.

Dan

Did it work?

Hi Ted--Daniel here again---wondering if you can help. building a cigar box fender spec bass. one jazz pickup, one 4 pole "vintage pickup", and my traditional two piezos under the bridge. I'm going to use traditional jazz bass pots. so here's my question. the pots are not hooked up, but all the wires from the pickups are routed though the future jack hole. i used alligator clips(jumpers) to test the pick-ups, and am getting more buzzing than i ever have. kicking in the piezos calms it down as usual, but it's still bad. the bridge is grounded. the other weird thing is when i put my hand on the strings, which usually quiets it down, the buzz changes but is still there. COULD IT BE THE ALLIGATOR CLIPS? (JUMPER WIRES).

Attachments:

It could be the jumpers.  I've solved some buzzing problems by resoldering all the solder points.  Try soldering it all together and see if the buzz is still there.  Good luck!

Bridge

Thank you Ted, I wasn't too confident with the jumpers.

On-line the suggestion is that I shield the box with copper tape. If you don't mind another question, when I install my harness, which is already grounded (or will be) to the jack, should I keep it away from the copper. In other words, if I nest the pots in the holes with the copper, won't it create a ground loop. In one video I watched the guy put the grounded harness right into the copper. Thank you.

The copper tape is conductive and meant to be part of the ground circuit.  I usually use conductive paint in my cavities and solder a ground wire to a small brad inside the cavity.  Also, if there's a pickguard lined with copper tape, I usually run a ground wire with a stripped end which will contact the copper when the guard is screwed in place.

Thank you. Then I assume the jack would also be in the copper, even though it's grounded from the last pot? I really appreciate learning this, I thought there shouldn't be multiple paths to ground. (jack) Certainly makes it much easier. Sorry to be redundant, just a good understanding of ground is certainly sound.

Ted, I am trying to wire my first electric guitar and am using Snake oil Humbuckers from Gitty. They only have a single wire with what I assume is a hot wire and a braided ground wrap. Would I just use the 2 pickup each with a tone and volume pot, 3 way switch and jack schematic for this. Thanks, John

Correct John - hot wire and braided ground.  I would use the 2 vol/tone/3 way diagram.  

Hi Ted: Hope you'll be able to enlighten me. Maybe you have one of these diagrams out there and I missed it. I have a one mag pickup, tone and volume config on a CBG. Is there a way to put a peizo in there and just be able to add a toggle switch that will switch me back and forth from mag to peizo?

Thanks, Tm

Not really Tim, a toggle will only let you switch on/off one pup,  with both mag and piezo you need independent volume controls to be able to play thru both and hear the piezo. In theory you can activate the piezo (without volume) with a toggle and crank the mag volume down to hear both.  But if you use a 3 way switch and 2 volume controls instead of a toggle you can play thru one or the other or both.  I recommend using volume for both pups because of the huge difference in output so you can get a good balance when played together.  This wiring diagram is how I do it:

Or you can use a blend pot instead of a 3 way:

Or go without a switch and both out to the jack (I don't like this, I like to be able to remove the piezo from the circuit, more than just turning piezo volume to zero):

Good Luck!

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building BasicsCigar Box Guitar Parts Store

Site Sponsor

Recommended Links & Resources

Discussion Forum

Dealing with hum...

Started by James Pobog. Last reply by Tom T Aug 30. 4 Replies

Output method

Started by Holly Hodson. Last reply by Tim Pannabecker May 13. 4 Replies

Copper foil tape as shield.

Started by Arthur Payne. Last reply by Arthur Payne May 2. 5 Replies

Why have a switch?

Started by Arthur Payne. Last reply by ILL GREEN Apr 12. 3 Replies

Problem with second-hand amp.

Started by Arthur Payne. Last reply by Arthur Payne Apr 2. 5 Replies

Added the CB Gitty “Psycho Knob”

Started by Tim Pannabecker. Last reply by Paul Craig Mar 8. 16 Replies

Lipstick pickup and Telecaster neck pickup. What goes where?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Mar 1. 12 Replies

Wiring CB Gitty Black Ice Single Coil

Started by ILL GREEN. Last reply by ILL GREEN Jan 9. 5 Replies

Minimal effect from volume or tone pot

Started by Arthur Payne. Last reply by Paul Craig Dec 21, 2018. 9 Replies

Problem posting discussion

Started by Arthur Payne. Last reply by Paul Craig Dec 17, 2018. 2 Replies

Creackle from Volume and Tone pots

Started by Arthur Payne. Last reply by Arthur Payne Nov 27, 2018. 3 Replies

Vol, tone, 3 way toggle and 2 single coils?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Paul Craig Nov 25, 2018. 20 Replies

two picksups - both or separate

Started by Reynhard Boegl. Last reply by Reynhard Boegl Sep 27, 2017. 8 Replies

Psycho knob

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 4 Replies

Psycho knob install

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 13 Replies

Psycho knob

Started by bizzaro guitaro Sep 18, 2017. 0 Replies

I cheated and bought a solderless wiring harness. Naughty boy!

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Aug 18, 2017. 46 Replies

Capacitor

Started by Rose Ericson. Last reply by Rose Ericson Jul 8, 2017. 2 Replies

Wiring A Dual Rail Pickup into A Cbg

Started by Philip Hale. Last reply by Paul Craig Jun 2, 2017. 5 Replies

Blog Posts

Mama Pearson's Soaporium

Posted by Rick Tish on September 14, 2019 at 8:52pm 0 Comments

Fresh Diddley Bow- "Why Not?"

Posted by Glenn Kaiser on September 13, 2019 at 10:23pm 1 Comment

Good weekend selling

Posted by Rick Tish on September 11, 2019 at 10:13pm 0 Comments

Cigar Box Guitar Music - Old time Blues

Posted by John on September 9, 2019 at 6:00pm 2 Comments

The Accidental Canjo

Posted by Poorness Studios on September 8, 2019 at 10:30am 2 Comments

Latest Activity

Eric Reille joined Mark "Fatt Max" Hill's group
Thumbnail

New Zealand CBG Movement

Kia Ora...Somewhere for all CBG people in the land of the long white cloud to get together and talk…See More
1 hour ago
Josh Thompson liked Dickie's photo
1 hour ago
Eric Reille liked Will Carter's group Australian CBG
3 hours ago
James Pobog posted a discussion

Build #2

Build #2 is underway.Not particularly an original design, but I'm still using these early builds as…See More
3 hours ago
Will "KOOL DOG HOOCH" Bonner liked Taffy Evans's discussion Just off the bench, latest build.
4 hours ago
James Pobog replied to Taffy Evans's discussion Just off the bench, latest build.
"Man, you are SO far out of my league...."
4 hours ago
Dave Lynas liked John's video
4 hours ago
Dave Lynas commented on John's video
Thumbnail

1957 Admiral Radio Hacked into an Atomic Guitar Amplifier

"Wonderful Sound John. Your guitars and amps are treasures."
4 hours ago
Steve Holladay commented on Steve Holladay's video
Thumbnail

Angeline the Baker

"Thanks, but not very fancy.  Android app "Acapella" takes all the work out of it."
4 hours ago
Dave Lynas liked Steve Holladay's video
5 hours ago
Dave Lynas commented on Steve Holladay's video
Thumbnail

Angeline the Baker

"Excellent string band sound. Loved it Steve. Fancy edit and sync."
5 hours ago
John posted a video

1957 Admiral Radio Hacked Atomic Guitar Amplifier

Cigar Box Guitars for sale at https://www.3-string-guitar.com 3 and 4 string cigar box guitars for sale at https://reddogguitars.com or Google search - Red D...
5 hours ago

Music

Loading…

© 2019   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->