Ready to start my next build and going through the planning stage at the moment. I’m trying to use up spare parts I already have rather than buying more stuff. Got to keep costs down.

Here’s the question anyway. I’ve got a Telecaster neck pickup and a lipstick pickup that I’d like to use. Would you put the Telecaster neck pickup in the neck position as it was designed to be used or would you put that one in the bridge position to give the lipstick pickup pride of place in the neck position? If folks could say which way they’d do it and perhaps why (so I can learn from the accumulated knowledge of Cigar Box Nation) then I’d really appreciate the help.

Thanks in advance and best regards to you all.

Bear :0)

Views: 114

Replies to This Discussion

My suggestion would be to test out the pickups first and see what you like the best.

You can temporarily hook up the pickups to a jack, and run a guitar cable from the jack to an amp.

Hold the pickups above the strings, either with your hand, or you can devise a temporary holder with something like some small blocks of wood and some tape. 

Thanks Skeesix. Good suggestion there. Think I’ll try that but was wondering if a lipstick pickup in the neck position was technically more appropriate for blues than a Telecaster neck pickup, as in this situation. I definitely think your common sense approach is a winning idea though. No idea why I didn’t consider that automatically myself.

Thanks again and all the best. :0)

Hi Bear,

Usually the higher output pickup goes in the bridge position (particularly when you buy a paired set).  For a telecaster neck pickup and a lipstick pickup both are fairly low output so I doubt it will make much difference.  Normally you aim for both pickups to be of a similar volume so there is no large noticeable difference when you switch from one to the other.  The strings move less at the bridge so a higher output pickup is used.  If you find a noticeable difference you can always adjust the output by adjusting the pickup heights (nearer the strings = more output = louder) to get a volume match.

Pickups vary in their tonal "voice" so you might find one does sound better at the neck or at the bridge.  Like Skeesix suggests doing a quick check will let you know.

Regards,

David L.

Hi David.

Good to be speaking with you. Thanks for coming in and offering your help and advice too. I didn’t know that both of my available pickups were fairly low output so that helps and good to know that it won’t make much difference which way around they go. I’ll definitely give them a test placement first though so thank you both for that. The distance from the strings information will definitely help so that’s gone in the old skull bank ready for when I get to that stage of the build! All really useful information and I’m very grateful for it.

 Thanks again David. Hope you’re doing well and good to hear from you again. Had some potentially bad news this end and have an appointment booked with the neuro surgery team in early April. Staying positive though and believing that all will be well in the long term. No point getting all down about these things and the treatment may not even turn out to be surgery anyway, right? It’s amazing what those guys can do nowadays.

Anyway, good to speak with you again and thanks for the advice. Much appreciated.

Bear :0)

Hope every thing goes well with the surgery or whatever treatment they do.

Thanks again Paul. I’m believing everything will be fine :0) Positivity goes a long way I believe!!

Me too, your in my prayers.

Thanks Paul :0)

If your doing one in the neck and one in the bridge position, put the hotter of the 2 in the bridge. use a 3-way blade switch or a 4-way blade switch for extra series option.

You could put both side by side in the middle and wire them to a 4-way switch. You could use either pickup alone or both in parallel or series. Or both in the neck or both in the bridge. Lots of options.

Thanks for coming in to help again Paul. Always great to have your opinion on things. Well, a lot of that went totally over my head but it gives me words to base my research around so thank you yet again. I’ll particularly look at wiring in series and in parallel. I particularly like the idea of looking at the possibility of having them both towards the neck position. That sounds exciting.

 Thanks again and hope you’re doing okay? I really appreciate you coming to my rescue as you always do.

All the best.

Bear :0)

Google search for Telecaster wiring scheme will help you with a regular 2 pickup wiring. 4-way switching is a bit more involved, but I have a schematic for that(did it on my green glitter avatar git) and I'll help you along.

That will be great. You’re a star Paul. Thanks again and speak soon. Off to bed here but will message when I’m at the wiring stage of the build. Really appreciate your help. :0)

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building BasicsCigar Box Guitar Parts Store

Site Sponsor

Recommended Links & Resources

Discussion Forum

Output method

Started by Holly Hodson. Last reply by KOOL DOG HOOCH Sep 22. 5 Replies

Creackle from Volume and Tone pots

Started by Arthur Payne. Last reply by KOOL DOG HOOCH Sep 22. 4 Replies

Dealing with hum...

Started by James Pobog. Last reply by KOOL DOG HOOCH Sep 22. 6 Replies

Copper foil tape as shield.

Started by Arthur Payne. Last reply by Arthur Payne May 2. 5 Replies

Why have a switch?

Started by Arthur Payne. Last reply by ILL GREEN Apr 12. 3 Replies

Problem with second-hand amp.

Started by Arthur Payne. Last reply by Arthur Payne Apr 2. 5 Replies

Added the CB Gitty “Psycho Knob”

Started by Tim Pannabecker. Last reply by Paul Craig Mar 8. 16 Replies

Lipstick pickup and Telecaster neck pickup. What goes where?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Mar 1. 12 Replies

Wiring CB Gitty Black Ice Single Coil

Started by ILL GREEN. Last reply by ILL GREEN Jan 9. 5 Replies

Minimal effect from volume or tone pot

Started by Arthur Payne. Last reply by Paul Craig Dec 21, 2018. 9 Replies

Problem posting discussion

Started by Arthur Payne. Last reply by Paul Craig Dec 17, 2018. 2 Replies

Vol, tone, 3 way toggle and 2 single coils?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Paul Craig Nov 25, 2018. 20 Replies

two picksups - both or separate

Started by Reynhard Boegl. Last reply by Reynhard Boegl Sep 27, 2017. 8 Replies

Psycho knob

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 4 Replies

Psycho knob install

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 13 Replies

Psycho knob

Started by bizzaro guitaro Sep 18, 2017. 0 Replies

I cheated and bought a solderless wiring harness. Naughty boy!

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Aug 18, 2017. 46 Replies

Capacitor

Started by Rose Ericson. Last reply by Rose Ericson Jul 8, 2017. 2 Replies

Wiring A Dual Rail Pickup into A Cbg

Started by Philip Hale. Last reply by Paul Craig Jun 2, 2017. 5 Replies

Latest Activity

Clarky commented on Clarky's video
Thumbnail

Red Morning Light - Kings Of Leon - Cigar Box Guitar Cover

"Thanks Dave and John :) You've given me a thought Uncle J, I think Money For Nothing can…"
20 minutes ago
Clarky commented on Clarky's video
Thumbnail

How To Play Sweet Home Alabama by Lynyrd Skynyrd on Cigar Box Guitar

"Thanks very much folks, I love doing exactly what Danny says.  I know some of us never played…"
23 minutes ago
Bernie Edwards liked Bill Turner (Wunkyman)'s photo
50 minutes ago
Bernie Edwards liked Bill Turner (Wunkyman)'s photo
51 minutes ago
Bernie Edwards liked Miku's photo
52 minutes ago
BUGGY (C) replied to Slowpaw Steve T's discussion CIGAR BOX NATION CHRISTMAS ALBUM 2019
"Christmas dinner sorted!! ;>)"
1 hour ago
BUGGY (C) replied to Slowpaw Steve T's discussion CIGAR BOX NATION CHRISTMAS ALBUM 2019
1 hour ago
BUGGY (C) replied to Slowpaw Steve T's discussion CIGAR BOX NATION CHRISTMAS ALBUM 2019
"Steve how's it going?... yeh count me in for one...I will let you know more when I figure it…"
2 hours ago
Cause the Blue rat replied to Slowpaw Steve T's discussion CIGAR BOX NATION CHRISTMAS ALBUM 2019
"Thanks Slowpaw teve for doing this again. Something I look forward to participating and hearing…"
2 hours ago
BrianQ. liked Miku's photo
3 hours ago
BrianQ. liked Bill Turner (Wunkyman)'s photo
3 hours ago
BrianQ. replied to James Pobog's discussion Question about pre-amps
"I play through those amps all the time, no problem? How many inputs does it have, does it have an…"
4 hours ago

Music

Loading…

© 2019   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->