Ready to start my next build and going through the planning stage at the moment. I’m trying to use up spare parts I already have rather than buying more stuff. Got to keep costs down.

Here’s the question anyway. I’ve got a Telecaster neck pickup and a lipstick pickup that I’d like to use. Would you put the Telecaster neck pickup in the neck position as it was designed to be used or would you put that one in the bridge position to give the lipstick pickup pride of place in the neck position? If folks could say which way they’d do it and perhaps why (so I can learn from the accumulated knowledge of Cigar Box Nation) then I’d really appreciate the help.

Thanks in advance and best regards to you all.

Bear :0)

Views: 132

Replies to This Discussion

My suggestion would be to test out the pickups first and see what you like the best.

You can temporarily hook up the pickups to a jack, and run a guitar cable from the jack to an amp.

Hold the pickups above the strings, either with your hand, or you can devise a temporary holder with something like some small blocks of wood and some tape. 

Thanks Skeesix. Good suggestion there. Think I’ll try that but was wondering if a lipstick pickup in the neck position was technically more appropriate for blues than a Telecaster neck pickup, as in this situation. I definitely think your common sense approach is a winning idea though. No idea why I didn’t consider that automatically myself.

Thanks again and all the best. :0)

Hi Bear,

Usually the higher output pickup goes in the bridge position (particularly when you buy a paired set).  For a telecaster neck pickup and a lipstick pickup both are fairly low output so I doubt it will make much difference.  Normally you aim for both pickups to be of a similar volume so there is no large noticeable difference when you switch from one to the other.  The strings move less at the bridge so a higher output pickup is used.  If you find a noticeable difference you can always adjust the output by adjusting the pickup heights (nearer the strings = more output = louder) to get a volume match.

Pickups vary in their tonal "voice" so you might find one does sound better at the neck or at the bridge.  Like Skeesix suggests doing a quick check will let you know.

Regards,

David L.

Hi David.

Good to be speaking with you. Thanks for coming in and offering your help and advice too. I didn’t know that both of my available pickups were fairly low output so that helps and good to know that it won’t make much difference which way around they go. I’ll definitely give them a test placement first though so thank you both for that. The distance from the strings information will definitely help so that’s gone in the old skull bank ready for when I get to that stage of the build! All really useful information and I’m very grateful for it.

 Thanks again David. Hope you’re doing well and good to hear from you again. Had some potentially bad news this end and have an appointment booked with the neuro surgery team in early April. Staying positive though and believing that all will be well in the long term. No point getting all down about these things and the treatment may not even turn out to be surgery anyway, right? It’s amazing what those guys can do nowadays.

Anyway, good to speak with you again and thanks for the advice. Much appreciated.

Bear :0)

Hope every thing goes well with the surgery or whatever treatment they do.

Thanks again Paul. I’m believing everything will be fine :0) Positivity goes a long way I believe!!

Me too, your in my prayers.

Thanks Paul :0)

If your doing one in the neck and one in the bridge position, put the hotter of the 2 in the bridge. use a 3-way blade switch or a 4-way blade switch for extra series option.

You could put both side by side in the middle and wire them to a 4-way switch. You could use either pickup alone or both in parallel or series. Or both in the neck or both in the bridge. Lots of options.

Thanks for coming in to help again Paul. Always great to have your opinion on things. Well, a lot of that went totally over my head but it gives me words to base my research around so thank you yet again. I’ll particularly look at wiring in series and in parallel. I particularly like the idea of looking at the possibility of having them both towards the neck position. That sounds exciting.

 Thanks again and hope you’re doing okay? I really appreciate you coming to my rescue as you always do.

All the best.

Bear :0)

Google search for Telecaster wiring scheme will help you with a regular 2 pickup wiring. 4-way switching is a bit more involved, but I have a schematic for that(did it on my green glitter avatar git) and I'll help you along.

That will be great. You’re a star Paul. Thanks again and speak soon. Off to bed here but will message when I’m at the wiring stage of the build. Really appreciate your help. :0)

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building BasicsCigar Box Guitar Parts Store

Site Sponsor

Recommended Links & Resources

Discussion Forum

Wickedbucker + Piezo +Volume Jack

Started by Adam Jellison. Last reply by Paul Craig Jan 16. 7 Replies

Output method

Started by Holly Hodson. Last reply by KOOL DOG HOOCH Sep 22, 2019. 5 Replies

Creackle from Volume and Tone pots

Started by Arthur Payne. Last reply by KOOL DOG HOOCH Sep 22, 2019. 4 Replies

Dealing with hum...

Started by James Pobog. Last reply by KOOL DOG HOOCH Sep 22, 2019. 6 Replies

Copper foil tape as shield.

Started by Arthur Payne. Last reply by Arthur Payne May 2, 2019. 5 Replies

Why have a switch?

Started by Arthur Payne. Last reply by ILL GREEN Apr 12, 2019. 3 Replies

Problem with second-hand amp.

Started by Arthur Payne. Last reply by Arthur Payne Apr 2, 2019. 5 Replies

Added the CB Gitty “Psycho Knob”

Started by Tim Pannabecker. Last reply by Paul Craig Mar 8, 2019. 16 Replies

Lipstick pickup and Telecaster neck pickup. What goes where?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Mar 1, 2019. 12 Replies

Wiring CB Gitty Black Ice Single Coil

Started by ILL GREEN. Last reply by ILL GREEN Jan 9, 2019. 5 Replies

Minimal effect from volume or tone pot

Started by Arthur Payne. Last reply by Paul Craig Dec 21, 2018. 9 Replies

Problem posting discussion

Started by Arthur Payne. Last reply by Paul Craig Dec 17, 2018. 2 Replies

Vol, tone, 3 way toggle and 2 single coils?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Paul Craig Nov 25, 2018. 20 Replies

two picksups - both or separate

Started by Reynhard Boegl. Last reply by Reynhard Boegl Sep 27, 2017. 8 Replies

Psycho knob

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 4 Replies

Psycho knob install

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 13 Replies

Psycho knob

Started by bizzaro guitaro Sep 18, 2017. 0 Replies

I cheated and bought a solderless wiring harness. Naughty boy!

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Aug 18, 2017. 46 Replies

Capacitor

Started by Rose Ericson. Last reply by Rose Ericson Jul 8, 2017. 2 Replies

Blog Posts

New Member need a little advice.

Posted by Don Paul on January 26, 2020 at 10:29am 3 Comments

Neck bowing

Posted by Mike Kinzie on January 24, 2020 at 5:38pm 2 Comments

Dual lap steel

Posted by Ron Lutz on January 9, 2020 at 2:42pm 4 Comments

My 3 Gitty Kits

Posted by Poorness Studios on January 8, 2020 at 9:20am 2 Comments

My CBG details

Posted by Paul scofield on January 1, 2020 at 9:22am 2 Comments

Latest Activity

Doug Krantz liked Cause the Blue rat's discussion Beginner guitar playing tips by a seasoned player (40+ years )
5 minutes ago
Cause the Blue rat posted a discussion

Beginner guitar playing tips by a seasoned player (40+ years )

First beginners always have this wrong. Your strumming hand is the most important hand. That is why…See More
19 minutes ago
Dennis "Denbo" Goodinson commented on Dave Lynas's video
Thumbnail

Where the Soul of Man Never Dies

"The Sermonizers, bringing the sound of Gospel to the masses through the interweb with true…"
33 minutes ago
Mark posted a discussion

Best design for cigar box Fiddle?

Howdy. I have had a lot of luck with getting cb Ukes to sound VERY good.  Not so much with a cb…See More
1 hour ago
Rob Uker liked larry kraus's photo
1 hour ago
Derek Rose commented on Derek Rose's video
Thumbnail

Blues & Whiskey

"Thanks much Bob. I had written most of it in the summer and worked on edits on and off in between…"
1 hour ago
Uncle John commented on Dave Lynas's video
Thumbnail

Where the Soul of Man Never Dies

"This is big smile wonderful.  You guys are such good singers and…"
1 hour ago
Uncle John commented on Uncle John's video
1 hour ago
Derek Rose commented on Dan Bolick's video
Thumbnail

Jack Daniels custom built 3 string guitar demo testing

"Nice clean and well made looking cbg. Nice tone too."
1 hour ago
Derek Rose liked Dan Bolick's video
1 hour ago
Derek Rose liked Dave Lynas's video
2 hours ago
Derek Rose commented on Dave Lynas's video
Thumbnail

Where the Soul of Man Never Dies

"Always great to hear some Sunday gospel. Nicely done and dubbed Dave. This would sound good on a…"
2 hours ago

Music

Loading…

© 2020   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->