Just got some parts arrived for my next build which is a VW Hubcap guitar.
The pickup I am going to fit is a single coil (sized) twin rail humbucker. Which comes with wiring that I'm not familiar with, I suspect the extra wires are for out of phase switching, but my knowledge of wiring is sketchy and limited.
My question is that my desired setup is this one pickup, with a volume and tone controls, and in and out of phase switching either by a switch or with a push pull pot.
First I really need a circuit diagram, bearing in mind that I'm not au fait with wiring symbols, and also to know wether 250 or 500k pots will be best, and will any capacitor be required and if so include this in the schematic.
I want a deeper sound with bite rather than a trebly jangle, and I will be placing the pickup in the neck position.
By the way for any of you who know of me, re the operation I had last October which unfortunately caused me to have no feeling in my right hand, I got a phone call this morning to confirm the operation date to hopefully God willing put it right, will happen on the 22nd of November, so fingers crossed.
Hope someone can help, as I have all the components for this build coming this week and I would love to get it sorted before going into hospital. I have attached a picture of the pickup wires, so thanks in anticipation.
Best Wishes
Phil Hale uk

Views: 305

Attachments:

Replies to This Discussion

Thanks for that Wayfinder, much appreciated.

From your pic, the red and blue wires twisted together are the end of the first coil and the start of the other coil, leaving white for hot and black and the bare wires for ground. This would be for typical series humbucking mode.

If you want to do a series/parallel or coil tap, then you'll need to disconnect the red and blue wires and wire them to a switch/pot. From what I'm seeing in the pic: white=hot and red would be the end of that coil/ground and the next coil would be blue=hot to black for the end of that coil/ground.

What I would suggest is wiring the pickup to a 4-way selector switch to 1 volume and 1 tone w/cap, then to the jack. Wiring the HB to that switch as 2 singles would be easy and allow you to play either coil separate, both coils together in parallel or both together in series.

Thank for that Paul. I will digest that and figure out the way forward.
Best Wishes Phil

I think I bought the same part, one pre-wired and one just the pickup. Here is the wiring diagram, hopefully without errors. I was wanting to split the coils of an old Epiphone humbucker and use this wiring.

Attachments:

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building BasicsCigar Box Guitar Parts Store

Site Sponsor

Recommended Links & Resources

Discussion Forum

Output method

Started by Holly Hodson. Last reply by Tim Pannabecker May 13. 4 Replies

Copper foil tape as shield.

Started by Arthur Payne. Last reply by Arthur Payne May 2. 5 Replies

Why have a switch?

Started by Arthur Payne. Last reply by ILL GREEN Apr 12. 3 Replies

Problem with second-hand amp.

Started by Arthur Payne. Last reply by Arthur Payne Apr 2. 5 Replies

Added the CB Gitty “Psycho Knob”

Started by Tim Pannabecker. Last reply by Paul Craig Mar 8. 16 Replies

Lipstick pickup and Telecaster neck pickup. What goes where?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Mar 1. 12 Replies

Wiring CB Gitty Black Ice Single Coil

Started by ILL GREEN. Last reply by ILL GREEN Jan 9. 5 Replies

Minimal effect from volume or tone pot

Started by Arthur Payne. Last reply by Paul Craig Dec 21, 2018. 9 Replies

Problem posting discussion

Started by Arthur Payne. Last reply by Paul Craig Dec 17, 2018. 2 Replies

Creackle from Volume and Tone pots

Started by Arthur Payne. Last reply by Arthur Payne Nov 27, 2018. 3 Replies

Vol, tone, 3 way toggle and 2 single coils?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Paul Craig Nov 25, 2018. 20 Replies

two picksups - both or separate

Started by Reynhard Boegl. Last reply by Reynhard Boegl Sep 27, 2017. 8 Replies

Psycho knob

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 4 Replies

Psycho knob install

Started by bizzaro guitaro. Last reply by bizzaro guitaro Sep 19, 2017. 13 Replies

Psycho knob

Started by bizzaro guitaro Sep 18, 2017. 0 Replies

I cheated and bought a solderless wiring harness. Naughty boy!

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Aug 18, 2017. 46 Replies

Capacitor

Started by Rose Ericson. Last reply by Rose Ericson Jul 8, 2017. 2 Replies

Wiring A Dual Rail Pickup into A Cbg

Started by Philip Hale. Last reply by Paul Craig Jun 2, 2017. 5 Replies

Buzz or maybe humm

Started by Rose Ericson. Last reply by Paul Craig Mar 12, 2017. 8 Replies

Blog Posts

My mistake at the markets

Posted by Rick Tish on August 22, 2019 at 9:27am 1 Comment

Indiana State Fair

Posted by Rick Tish on August 19, 2019 at 7:46pm 1 Comment

Buying in bulk

Posted by Rick Tish on August 17, 2019 at 6:31pm 3 Comments

Shellac

Posted by Rick Tish on August 15, 2019 at 7:00pm 1 Comment

Latest Activity

Jeff 'Bones' Reilly commented on AGP #'s photo
Thumbnail

AGP #365 - ''Susie Q''

"Yep got a commissioned build on the bench other than that been to busy. "
28 minutes ago
Dave Lynas commented on cbgkent's video
Thumbnail

Preachin blues and black Betty jam CBG

"Nice to hear you singing Kent. :D) I like the preaching Blues best."
33 minutes ago
Dave Lynas liked cbgkent's video
35 minutes ago
Dave Lynas posted a video

Jamin with Clint

Clint Spotts visit to the garden to jam and picnic. Clint’s new Swamp Witch and his Crate Guitar, my Moon Man Guitar and 2 string Bass.
49 minutes ago
Andries D. EKER commented on RTZGUITARS's video
Thumbnail

Summers End

"Fine picking & singing RTZ! i believe you are forgiven by now! sometimes somethings work !"
2 hours ago
Andries D. EKER commented on Downtown Vinnie's video
Thumbnail

Bass Fishin

"PUMPING ! NICE great  tone ,is that metal strings or nylon ?thats a track for some slide…"
2 hours ago
Andries D. EKER commented on Andries D. EKER's video
Thumbnail

Things that use to be A. D. Eker 2019

"Hiya RTZ ! thanks for your kind comments appriciated ! & GLAD YOU LIKED IT !"
2 hours ago
Andries D. EKER commented on Andries D. EKER's video
Thumbnail

Things that use to be A. D. Eker 2019

"Thanks Amos for your kind like ! appriciated !"
2 hours ago
Poorness Studios posted photos
2 hours ago
Will "KOOL DOG HOOCH" Bonner replied to Will "KOOL DOG HOOCH" Bonner's discussion Lid thickness question.
"Thanks Taff, my idea of the rod was to be a direct link from the bridge to the false bottom.…"
3 hours ago
Ben Ridgeway liked Tom T's discussion 67% Les Paul Tribute
3 hours ago
Taffy Evans replied to Will "KOOL DOG HOOCH" Bonner's discussion Lid thickness question.
"Hi Will, I will not go in depth on the subject as we are talking simple box design guitars, but I…"
3 hours ago

Music

Loading…

© 2019   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->