Replies to This Discussion

Permalink Reply by Darren Wolbold on April 16, 2012 at 1:56am

Hello

I usually solder the two black wires from the piezos together then solder them to the sleeve or ground connector on the jack socket. I solder the live red wires from the piezo together and then solder them to the input on pot as shownThe output needs a wire to the remaining signal connection on the jack. Finally I connect all the earth or ground connections up to stop humming. So the no 1 tab on the pot is connected to the case of the pot (as shown) and a connection from the pot case is made to the sleeve or ground connection on the jack.

Hope that helps

As for two Do you mean a tone knob as well?

check my blog out 

http://darrenscigarboxguitars.blogspot.co.uk/

• ▶ Reply

Permalink Reply by bizzaro guitaro on April 16, 2012 at 6:40am

Thanks for your help.I will try it that way. I was just thinking of two seperate volume controls,(one for each pup) no tone control,just a thought? Bizzaro

• ▶ Reply

Permalink Reply by Darren Wolbold on April 16, 2012 at 7:03am

Not done it my self, but hay there are no rules with these things !

Post some picks

• ▶ Reply