I have a few boxes which are small but quite deep, and I've started making an acoustic from one of them. What should I be doing to get the guitar as loud as possible? I usually do a neck through design. I know that the main point is how well the lid vibrates. So I'm guessing that glueing the neck inside the lid is a no no, also I should thin out the lid, but what about sound holes. Is bigger better? Is one round hole under the strings in the center best, or should I make several smaller holes? My last build had f holes which were reasonably big and it sounded decent but I just wanted to see what you good people think on this.
Any advice appreciated as always :)
Replies
My best results so far have been these two. The Viejo box is very small with two 1" sound holes in the corners towards the neck and the Partagas box is one of the biggest cigar boxes I've seen, ("Gigante") and I only put one 1 1/8" hole in it. Both have very good voices acoustically. As has been mentioned it seems like bigger holes don't help.
Just one in the upper corner works well too.
Thanks for the advice. I put some holes facing the player and on the soundboard, it looks nice, but I didn't notice it was any louder than normal. Some good tips here though, I will take them on board.
blues1.jpg
blues2.jpg
But not any less louder than normal?
Those patterns look nice and I think that is just as important as their function. Otherwise, just leave the decorative face of the box alone.
I've found that stiffening the long sides of the box with pine or poplar (lightweight scrap) increases the volume nicely.
I could really make an argument either way on gluing the neck to the lid. Have you felt how much the neck vibrates when the strings are picked or strummed? That is mostly wasted energy that might be better transmitted to the lid.
Next time, try a lot fewer big holes, especially. Literally one in the upper left shoulder, or maybe one in the side facing the player, should be enough. Others will undoubtedly disagree ;-).
Here is some advice..that works for me when using sound holes...smaller boxes..don't touch them...they are loud on their own..when building the inside find yourself old tangerine crates at the supermarket and recycle the triangular wood...then place and size it in the inside the box in all four corners and it will create a louder tone..but clean...but if adding a pickup leave one corner alone to drill the input jack..hopefully this adds a rounder inside of the box giving u a louder tone..lol wrks for me.. hope this was helpful
Melodeeman
Oh well I just bashed in a few pretty holes (that sounded wrong oops) so I'll see how it sounds when I string it up tomorrow.
There ya go!
I don't go any where near theory as regards making guitars...only results count. It reminds me of the joke about a French philosopher..."Ah, Monsieur, that is all very well in practice, but 'ow does it work in theory?"
-
1
-
2
of 2 Next