Replies to This Discussion

Permalink Reply by KOOL DOG HOOCH on August 1, 2019 at 10:19pm

I'm not an expert by no means, but with that being said. A rod Piezo (the tooth pick looking one) needs pressure to work properly. The best placement is in a slot under the bridge between the bridge and lid or better still a slot in the top of the bridge sandwiched with a bone saddle so when the strings are installed they are working at their best!

As far as Shane goes, if he says it works, it works. If you don't want to go the route of using a rod, use a disk type glued on the underside of the lid. Be forewarned it will pickup every little noise(it's basically a mic) you might want to consider a ribbon style(bow tie, violin) goes under bridge they are a pressure type. I don't have any experience with them yet, but I understand they are better then the rod type. Welcome to CBN!

• ▶ Reply

Permalink Reply by Steve Harbour on August 2, 2019 at 9:01am

Thanks, Will  

• ▶ Reply

Permalink Reply by KOOL DOG HOOCH on August 2, 2019 at 10:44am

My pleasure!

• ▶ Reply

Permalink Reply by Road Rash Roy on August 2, 2019 at 1:28am

Hello and welcome Steve.  

The rod piezo will not work on the side of the bridge.  As Will described, it is meant to have direct pressure from the strings to work properly and should be placed between the saddle and the top of the guitar.

I also trust any advice or tip that Shane Spiel gives out, but any other method for placing the rod piezo is probably a creative work-around for something.  

What are you using for your bridge/saddle?  Can you cut a small groove on the bottom of it for the piezo rod?  

• ▶ Reply

Permalink Reply by Steve Harbour on August 2, 2019 at 9:07am

Flying Kay style bridge, made out of Padauk.  Obviously no way to mount the rod in the bridge, so it’s going to have to be installed between the neck and the lid, directly beneath the bridge.  I’ll be sure the rod is under pressure so it doesn’t buzz.  Thanks for your help.  

• ▶ Reply