This will probably be one of the weirder first time posts. I coach a middle school science team, and this year there is a new event that challenges the kid to build a home made instrument that can accurately play a scale, and a simple tune, then tests them over the physics of instruments.
According to the rules the device may not contain any of the following "Electrical or electronic components, parts taken from or used in any toy or professional instrument. The only exception is strings.
So so after some quick googling at our first team meeting we stumbled across cigar box guitars and thought this is perfect. So how do I substitute for parts? I think we can make tuners by drilling a hole in a bolt. is there anything special about fret wire that I couldn't substitute some other wire for it? about what size should I be looking at.
We are probably going to build 2. One will be a 1 string, and the other a more typical 3 string. Would there be drawbacks to not doing all the frets, and just doing the ones we need for the scale and 4 measures of yankee doodle?
These will be built by the kids, but when they are done I'm going to make one for me. Thanks for the help.
hi, you could get away with not using frets at all. Just scribe and/or burn the positions into the fretboard.Taff
Check this out, super simple cbg, gives all info & measurements? Good luck :)
You could also use a sharpie or paint pen to mark the frets, maybe the easiest? You can also glue nails, wire or even wood frets on it, just measure the height of the frets off your favorite guitar if you’re not sure?
Tuners could also be wooden friction pegs like some student violins or fiddles.
I have seen small diameter nails used for frets. Or play fretless, as mentioned, by pressing where the frets would be.
This might help. They do use commercial guitar tuners. They also do a scarf joint for the headstock, which (IMHO) is a bit overboard.
You could also go fretless and use a slide. Mark fret location with a sharpie.