Replies to This Discussion

Permalink Reply by Diglydog on November 29, 2017 at 3:09am

Measuring string spacing at the bridge on commercially-built tenor ukes, my Mahalo is 13mm and the Kala is a tiny bit less - 38.5mm across strings 1-4.  Both are just under 9mm at the nut - 26.5mm across strings 1-4.  I hope that this helps.

• ▶ Reply

Permalink Reply by Kigar on November 30, 2017 at 3:40pm

If you make a floating bridge it is a lot easier to make, and it can be any spacing you want, and you can adjust intonation as well.

• ▶ Reply

Permalink Reply by John Sawyer on November 30, 2017 at 7:09pm

Thanks.   I like the look and simplicity of the commercial bridge.  I've been using floating bridges on most of my guitars...  Nice looking uke!

Here's the latest...

• ▶ Reply

Permalink Reply by Kigar on December 1, 2017 at 11:32am

Nice! Did you make the bridge? Haven't seen one with offsets for a uke before.

• ▶ Reply

Permalink Reply by John Sawyer on December 1, 2017 at 11:46am

I make my bridges out of hardwood scraps left over from making fretboards. I make them on my belt sander, hollow the bottom on the rollers, cut grooves and then finish them with superglue...

• ▶ Reply

Permalink Reply by Kigar on December 2, 2017 at 9:24am

I do pretty much the same. How do you determine the offset for each string?

• ▶ Reply

Permalink Reply by John Sawyer on December 4, 2017 at 3:39pm

I use the TLAR method:  "That Looks About Right"   well, I cheated... a commercial compensated saddle was about 1/8" off.  The others are tapered forward to about the same position.   Since this is a floating bridge, I get pretty darn close to perfect and then glue it in place.

• ▶ Reply