Click PAUSE on the diagram you need then click the pic to open it in a new window.

Need a diagram not here?  Just ask

.http://handmademusic.ning.com/photo/photo/slideshow?albumId=4519676...

Found at my Handmade Music Clubhouse.  

Views: 7513

Replies to This Discussion

Ted,

I'm betting it will work. It erases some nasty hum on my guitars, always. I use disks, the only thing is you will get a signal from the piezo (ok so far for me), so it will add sound unless there's a separate volume control, which could be messy. (probably not for you). Or the piezo can be buried where it won't add to the signal. Best.

Dan

Did it work?

Hi Ted--Daniel here again---wondering if you can help. building a cigar box fender spec bass. one jazz pickup, one 4 pole "vintage pickup", and my traditional two piezos under the bridge. I'm going to use traditional jazz bass pots. so here's my question. the pots are not hooked up, but all the wires from the pickups are routed though the future jack hole. i used alligator clips(jumpers) to test the pick-ups, and am getting more buzzing than i ever have. kicking in the piezos calms it down as usual, but it's still bad. the bridge is grounded. the other weird thing is when i put my hand on the strings, which usually quiets it down, the buzz changes but is still there. COULD IT BE THE ALLIGATOR CLIPS? (JUMPER WIRES).

Attachments:

It could be the jumpers.  I've solved some buzzing problems by resoldering all the solder points.  Try soldering it all together and see if the buzz is still there.  Good luck!

Bridge

Thank you Ted, I wasn't too confident with the jumpers.

On-line the suggestion is that I shield the box with copper tape. If you don't mind another question, when I install my harness, which is already grounded (or will be) to the jack, should I keep it away from the copper. In other words, if I nest the pots in the holes with the copper, won't it create a ground loop. In one video I watched the guy put the grounded harness right into the copper. Thank you.

The copper tape is conductive and meant to be part of the ground circuit.  I usually use conductive paint in my cavities and solder a ground wire to a small brad inside the cavity.  Also, if there's a pickguard lined with copper tape, I usually run a ground wire with a stripped end which will contact the copper when the guard is screwed in place.

Thank you. Then I assume the jack would also be in the copper, even though it's grounded from the last pot? I really appreciate learning this, I thought there shouldn't be multiple paths to ground. (jack) Certainly makes it much easier. Sorry to be redundant, just a good understanding of ground is certainly sound.

Ted, I am trying to wire my first electric guitar and am using Snake oil Humbuckers from Gitty. They only have a single wire with what I assume is a hot wire and a braided ground wrap. Would I just use the 2 pickup each with a tone and volume pot, 3 way switch and jack schematic for this. Thanks, John

Correct John - hot wire and braided ground.  I would use the 2 vol/tone/3 way diagram.  

Hi Ted: Hope you'll be able to enlighten me. Maybe you have one of these diagrams out there and I missed it. I have a one mag pickup, tone and volume config on a CBG. Is there a way to put a peizo in there and just be able to add a toggle switch that will switch me back and forth from mag to peizo?

Thanks, Tm

Not really Tim, a toggle will only let you switch on/off one pup,  with both mag and piezo you need independent volume controls to be able to play thru both and hear the piezo. In theory you can activate the piezo (without volume) with a toggle and crank the mag volume down to hear both.  But if you use a 3 way switch and 2 volume controls instead of a toggle you can play thru one or the other or both.  I recommend using volume for both pups because of the huge difference in output so you can get a good balance when played together.  This wiring diagram is how I do it:

Or you can use a blend pot instead of a 3 way:

Or go without a switch and both out to the jack (I don't like this, I like to be able to remove the piezo from the circuit, more than just turning piezo volume to zero):

Good Luck!

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building Basics

Site Sponsor

Recommended Links & Resources


Discussion Forum

Swamp Lion Circuit- 3 P90s!

Started by ILL GREEN. Last reply by David Bowes Jul 31, 2022. 2 Replies

No Volume

Started by Steve Bookout. Last reply by BrianQ. Jun 15, 2021. 15 Replies

External Power Adapter- How To

Started by BrianQ.. Last reply by BrianQ. Jun 23, 2020. 3 Replies

Wiring diagrams

Started by David L.. Last reply by Ray Stanis Mar 24, 2020. 10 Replies

Wickedbucker + Piezo +Volume Jack

Started by Adam Jellison. Last reply by Paul Craig Feb 28, 2020. 9 Replies

Psycho knob install

Started by bizzaro guitaro. Last reply by Paul Craig Jan 31, 2020. 16 Replies

Splitting P-Bass pickups?

Started by John Mark Perchalski. Last reply by Paul Craig Jan 30, 2020. 3 Replies

Output method

Started by Holly Hodson. Last reply by KOOL DOG HOOCH Sep 22, 2019. 5 Replies

Creackle from Volume and Tone pots

Started by Arthur Payne. Last reply by KOOL DOG HOOCH Sep 21, 2019. 4 Replies

Dealing with hum...

Started by James Pobog. Last reply by KOOL DOG HOOCH Sep 21, 2019. 6 Replies

Copper foil tape as shield.

Started by Arthur Payne. Last reply by Arthur Payne May 2, 2019. 5 Replies

Why have a switch?

Started by Arthur Payne. Last reply by ILL GREEN Apr 12, 2019. 3 Replies

Problem with second-hand amp.

Started by Arthur Payne. Last reply by Arthur Payne Apr 1, 2019. 5 Replies

Added the CB Gitty “Psycho Knob”

Started by Tim Pannabecker. Last reply by Paul Craig Mar 8, 2019. 16 Replies

Lipstick pickup and Telecaster neck pickup. What goes where?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Mar 1, 2019. 12 Replies

Wiring CB Gitty Black Ice Single Coil

Started by ILL GREEN. Last reply by ILL GREEN Jan 9, 2019. 5 Replies

Minimal effect from volume or tone pot

Started by Arthur Payne. Last reply by Paul Craig Dec 21, 2018. 9 Replies

Problem posting discussion

Started by Arthur Payne. Last reply by Paul Craig Dec 17, 2018. 2 Replies

Vol, tone, 3 way toggle and 2 single coils?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Paul Craig Nov 24, 2018. 20 Replies

Latest Activity

Southern Ray commented on Southern Ray's photo
Thumbnail

Project Punch!

" Thank ya again Keith!"
8 minutes ago
Southern Ray commented on Southern Ray's photo
Thumbnail

Punch Project!

" Thank Ya Keith!"
12 minutes ago
Doug Thorsvik commented on AGP #'s photo
Thumbnail

AGP #527 - ''Led-Zep 2''

"This build really strung you along Alan! Reminded me of all my fishing line experiments; a lot of…"
1 hour ago
Doug Thorsvik commented on A.D.EKER's video
Thumbnail

Im Troubled (Tribute) Mc K Morganfield by BCB - A.D .Eker 2024.

"Diggin’ the slow blues. I like that last pic Andries! Look at all those cool guitars. Yeah!!!"
1 hour ago
Dar Stellabotta posted a video

A Cigar Box Guitar Six Stringer Built by Louie Lamanna

This video is the unboxing and the demonstration of a beautiful, six stringer built by Louie Lamanna. Join Louie and I June 15 at the second annual Pittsburg...
3 hours ago
Doug Thorsvik commented on Doug Thorsvik's video
Thumbnail

Hail the Resurrection Day: 2-String Violin Chugger Cigar Box Guitar

"Happy Easter to you too Andries! The passion is definitely in full swing. Turns out I’m…"
3 hours ago
A.D.EKER commented on Doug Thorsvik's video
Thumbnail

Hail the Resurrection Day: 2-String Violin Chugger Cigar Box Guitar

"Happy Easter Doug ! the Passion is in full swing !"
4 hours ago
A.D.EKER commented on Ricky D's photo
4 hours ago
A.D.EKER commented on A.D.EKER's video
4 hours ago
Keith Rearick liked Doug Thorsvik's video
8 hours ago
Keith Rearick liked A.D.EKER's video
8 hours ago
Keith Rearick liked Doug Thorsvik's video
8 hours ago

Music

© 2024   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->