Replies to This Discussion

Permalink Reply by PhilUSAFRet on December 28, 2012 at 2:23am

This 1/8" jack fits into a preamp/eq that is mounted in the side of the instrument.  Your pickup is also wired to it to comprise a "pickup system."  Often, the endpin jack comes with the preamp/eq but sometimes they aren't as nice as the ones you have, especially if they are the cheaper Chinese ones. Now all you need is the preamp/eq, a pickup, and a battery and you will have an "active" pickup system for your instrument

Permalink Reply by Chris Thomas on December 28, 2012 at 3:47am

Hi Phil, thank you for the help, I would like to know if the red and white wires from the pre-amp to the jack socket can be pulled out and swapped over or are they soldered on, the pre-amp looks like thisCould I cut the red and white wires on one of the jack's and solder to a single coil and pots? If so which wire goes where?

Thank you, Chris. :)

Permalink Reply by Skeesix on December 28, 2012 at 3:52pm

Stick a guitar cable (1/4 plug) into the jack. The tip of the plug will touch metal that goes to the lead wire. The other wire will be the ground.

If you're not sure, you can always get some of those alligator clip lead wires (Radio Shack has them) and hook up things temporarily to test them out. If the circuit is correct, it will work. If it's not correct, it won't.

Sketching out a little wiring diagram can help with visualizing how the current is flowing in the circuit and therefore, how it should be hooked up.

Permalink Reply by Chris Thomas on December 28, 2012 at 11:35pm

Thank you Skeesix, I will try that out. What pots do I need to wire to a single coil? If I purchase a A250k volume pot and a B250k tone pot and a capacitor a single coil pickup with the end pin jack above have I got every thing I need? All the best mate, Chris. :)

Permalink Reply by PhilUSAFRet on December 28, 2012 at 4:10am

Yes, but I think there are many others here who can give you way better instructon on this than me.

Permalink Reply by Chris Thomas on December 28, 2012 at 4:18am

Thank you Phil, all the best mate, Chris. :)