I was trying to use an AC adapter for one of my CB amps, but when I plug it in, there is a loud humming/buzzing coming from the speaker.

 

The adapter is a 12v DC, 1 amp unit. Am I trying to use too many volts or amps? The red pilot light gets very bright when I plug it in, much brighter than when I use just the 9v battery.

 

Thanks

 

Views: 1200

Replies to This Discussion

Dan, I have been doing some experiments with my amp boards and am having the same trouble when running it off an AC adapter. I haven't found the solution yet. Glad you posted this though, maybe some electrical engineer out there will know!

I did find mention of using a "regulated" AC adapter, but I am not sure how I would know if the ones I am trying are regulated or not.

 

 

That is the direction my research has been heading too. Pretty sure all of the test adapters I got for testing are unregulated... I have to dig through my spare electronics bits bucket to see if I have an old 9-12V adapter in the 1000mA range to see if it makes a difference.

My best guess at this point is that if it has a little cylindrical-shaped thinger just behind the small plug where you plug it into the amp, it may be regulated. I know I have seen a lot of wall warts that have this, but all of the ones I have been using for testing do not. Worth a try.

OK, found one on eBay that says Regulated right on it. This may be the problem. It appears an un-regulated power supply provides varying amounts of juice which can cause the hum. I just need to confirm the minimum mah rating that the amp requires.

 

The power supplies I have been testing with are definitely DC. I have a couple of regulated DC options on the way too Dan, though I don't know that 300mA will be quite enough to drive the amp circuit quite as hard as you'd want. 9V batters tend to vary in range from about 750mA to ~1200mA for the high-energy lithium batteries, according to wikipedia. I am aiming for 9V 1000mA regulated at the moment.

it should be easy to tell if your power supply is regulated or not. 

with no load on the supply, a regulated supply should read very close to the rated voltage on a multimeter, a non regulated supply will read usually quite a bit higher than rated when it has no load.

as elwood says, make sure you have DC out, and other than that i would tripple check your polarity.  buzzing like this is usually caused by voltage on the earth rail.

if your supply isn't regulated, it is a pretty simple build to make a voltage regulator that should also help to smooth any ripple voltage.  i'll dig around for a schematic and post it or a link.  a regulator chip does drop the voltage a little though, so a 12VDC supply might only do 10VDC regulated.

e

a couple of regulator links

http://www.circuitstoday.com/fixed-positive-voltage-regulators

http://www.circuitstoday.com/adjustable-voltage-regulators

and if your power supply is AC you'll need to rectify it first like this...

http://www.techlib.com/electronics/regulators.html

hope this helps.

e

I don't think it has anything to do with regulated or nonregulated. All that has more to do with keeping your voltage constant. This has more to do with filters. I don't remember all the terms, but when you go from 120ac to 12 vdc you get noise (for lack of a better term).Remember the old days when you would get ignition noise on your car radio & had to have a filter? Similar problem. It's not hard or expensive to fix, I just haven't had time to experiment with it yet. I'm sure the answer is on here somewhere. If you come up with a cheap fix, post it. I've built some 15watt/12VDC Amps that sound a lot better with eight AA batteries than plugged in to my $15 120vac to 12vdc adapters.

ps: I think the fat part on some of the cords is actually a filter. It may be as simple as some kind of cap. I used to know all this stuff before I got old & senile.

kinda true bob, but not really seperate.

i think you are talking about ripple from the original AC current being present in the DC output and coming out as 50/60 htz hum or 100/120 htz hum depending on how it was rectified. yes, filtering of the DC will help this.

but the regulated supply thing isn't a bum-steer.

voltage regulators are quite good at filtering ripple currents on their own, and as regulated power supplies are usually better quality to start with, they probably have better filtering on board as well.

if space isn't an issue you can use a junked computer PSU to give you a massive 12v supply, 15-30amps!  i have a couple i use as benchtop powersupplies for testing stuff as they also have 3.3v and 5v rails.

RSS

The Essential Pages

New to Cigar Box Nation? How to Play Cigar Box GuitarsFree Plans & How to Build Cigar Box GuitarsCigar Box Guitar Building Basics

Site Sponsor

Recommended Links & Resources


Discussion Forum

Swamp Lion Circuit- 3 P90s!

Started by ILL GREEN. Last reply by David Bowes Jul 31, 2022. 2 Replies

No Volume

Started by Steve Bookout. Last reply by BrianQ. Jun 15, 2021. 15 Replies

External Power Adapter- How To

Started by BrianQ.. Last reply by BrianQ. Jun 23, 2020. 3 Replies

Wiring diagrams

Started by David L.. Last reply by Ray Stanis Mar 24, 2020. 10 Replies

Wickedbucker + Piezo +Volume Jack

Started by Adam Jellison. Last reply by Paul Craig Feb 28, 2020. 9 Replies

Psycho knob install

Started by bizzaro guitaro. Last reply by Paul Craig Jan 31, 2020. 16 Replies

Splitting P-Bass pickups?

Started by John Mark Perchalski. Last reply by Paul Craig Jan 30, 2020. 3 Replies

Output method

Started by Holly Hodson. Last reply by KOOL DOG HOOCH Sep 22, 2019. 5 Replies

Creackle from Volume and Tone pots

Started by Arthur Payne. Last reply by KOOL DOG HOOCH Sep 21, 2019. 4 Replies

Dealing with hum...

Started by James Pobog. Last reply by KOOL DOG HOOCH Sep 21, 2019. 6 Replies

Copper foil tape as shield.

Started by Arthur Payne. Last reply by Arthur Payne May 2, 2019. 5 Replies

Why have a switch?

Started by Arthur Payne. Last reply by ILL GREEN Apr 12, 2019. 3 Replies

Problem with second-hand amp.

Started by Arthur Payne. Last reply by Arthur Payne Apr 1, 2019. 5 Replies

Added the CB Gitty “Psycho Knob”

Started by Tim Pannabecker. Last reply by Paul Craig Mar 8, 2019. 16 Replies

Lipstick pickup and Telecaster neck pickup. What goes where?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Slow Blues Dani & Ol' Grey Bear Mar 1, 2019. 12 Replies

Wiring CB Gitty Black Ice Single Coil

Started by ILL GREEN. Last reply by ILL GREEN Jan 9, 2019. 5 Replies

Minimal effect from volume or tone pot

Started by Arthur Payne. Last reply by Paul Craig Dec 21, 2018. 9 Replies

Problem posting discussion

Started by Arthur Payne. Last reply by Paul Craig Dec 17, 2018. 2 Replies

Vol, tone, 3 way toggle and 2 single coils?

Started by Slow Blues Dani & Ol' Grey Bear. Last reply by Paul Craig Nov 24, 2018. 20 Replies

Latest Activity

BrianQ. commented on Dar Stellabotta's video
1 hour ago
BrianQ. liked Dar Stellabotta's video
1 hour ago
Southern Ray commented on Southern Ray's photo
Thumbnail

Project Punch!

" Thank ya again Keith!"
4 hours ago
Southern Ray commented on Southern Ray's photo
Thumbnail

Punch Project!

" Thank Ya Keith!"
4 hours ago
Doug Thorsvik commented on AGP #'s photo
Thumbnail

AGP #527 - ''Led-Zep 2''

"This build really strung you along Alan! Reminded me of all my fishing line experiments; a lot of…"
5 hours ago
Doug Thorsvik commented on A.D.EKER's video
Thumbnail

Im Troubled (Tribute) Mc K Morganfield by BCB - A.D .Eker 2024.

"Diggin’ the slow blues. I like that last pic Andries! Look at all those cool guitars. Yeah!!!"
5 hours ago
Dar Stellabotta posted a video

A Cigar Box Guitar Six Stringer Built by Louie Lamanna

This video is the unboxing and the demonstration of a beautiful, six stringer built by Louie Lamanna. Join Louie and I June 15 at the second annual Pittsburg...
7 hours ago
Doug Thorsvik commented on Doug Thorsvik's video
Thumbnail

Hail the Resurrection Day: 2-String Violin Chugger Cigar Box Guitar

"Happy Easter to you too Andries! The passion is definitely in full swing. Turns out I’m…"
7 hours ago
A.D.EKER commented on Doug Thorsvik's video
Thumbnail

Hail the Resurrection Day: 2-String Violin Chugger Cigar Box Guitar

"Happy Easter Doug ! the Passion is in full swing !"
8 hours ago
A.D.EKER commented on Ricky D's photo
8 hours ago
A.D.EKER commented on A.D.EKER's video
8 hours ago
Keith Rearick liked Doug Thorsvik's video
12 hours ago

Music

© 2024   Created by Ben "C. B. Gitty" Baker.   Powered by

Badges  |  Report an Issue  |  Terms of Service

\uastyle>\ud/** Scrollup **/\ud.scrollup {\ud background: url("https://storage.ning.com/topology/rest/1.0/file/get/963882636?profile=original") no-repeat scroll 0 0 transparent;\ud bottom: 25px;\ud display: inline !important;\ud height: 40px;\ud opacity: 0.3 !important;\ud position: fixed;\ud right: 30px;\ud text-indent: -9999px;\ud width: 40px;\ud z-index: 999;\ud}\ud.scrollup:hover {\ud opacity:0.99!important;\ud}\ud \uascript type="text/javascript">\ud x$(document).ready(function(){\ud x$(window).scroll(function(){\ud if (x$(this).scrollTop() > 100) {\ud x$('.scrollup').fadeIn();\ud } else {\ud x$('.scrollup').fadeOut();\ud }\ud });\ud x$('.scrollup').click(function(){\ud x$("html, body").animate({ scrollTop: 0 }, 600);\ud return false;\ud });\ud });\ud \ua!-- End Scroll Up -->